Sponsored

AeroForce Technology Interceptor

dozxab

Well-Known Member
First Name
Dave
Joined
Sep 14, 2024
Threads
13
Messages
508
Reaction score
1,489
Location
Prescott AZ
Vehicle(s)
2022 Ford Ranger XLT FX4, 2014 Jeep Wrangler JK
Occupation
Retired
I just set up my new Interceptor OBD2 gauge on my 2022 Ford Ranger. I have it set to display trans temp and boost. When I start the truck the display does not illuminate until I hit the 2 buttons. I contacted support and they told me to try non Ecoboost option. I replied to them that it did not work and there has been no reply. Anyone have one that has been through this?
Sponsored

 

Dr3wDrop

Well-Known Member
First Name
Andrew
Joined
Dec 14, 2021
Threads
38
Messages
1,242
Reaction score
2,292
Location
OHIO
Vehicle(s)
2021 Lariat Tremor
Remote start or not? My iDash does not turn on with remote start.
 
OP
OP
dozxab

dozxab

Well-Known Member
First Name
Dave
Joined
Sep 14, 2024
Threads
13
Messages
508
Reaction score
1,489
Location
Prescott AZ
Vehicle(s)
2022 Ford Ranger XLT FX4, 2014 Jeep Wrangler JK
Occupation
Retired
Remote start or not? My iDash does not turn on with remote start.
No. I've run into that problem before with another device. Just on normal startup with the key.
 


OP
OP
dozxab

dozxab

Well-Known Member
First Name
Dave
Joined
Sep 14, 2024
Threads
13
Messages
508
Reaction score
1,489
Location
Prescott AZ
Vehicle(s)
2022 Ford Ranger XLT FX4, 2014 Jeep Wrangler JK
Occupation
Retired
" 7. Connect switched 12v power (if necessary). The center pin of the 3-wire harness is for switched 12v power and is not required for virtually any CAN bus vehicle. "

It powers up normally after I press both buttons at once.
 

Colo_Ranger

Well-Known Member
Joined
Apr 19, 2021
Threads
49
Messages
3,796
Reaction score
12,891
Location
Colorado
Vehicle(s)
2021 Ford Ranger XLT FX4
Vehicle Showcase
1
" 7. Connect switched 12v power (if necessary). The center pin of the 3-wire harness is for switched 12v power and is not required for virtually any CAN bus vehicle. "

It powers up normally after I press both buttons at once.

Step 7 worked for me. I know it says it shouldn't be required but... it was for me.
 
OP
OP
dozxab

dozxab

Well-Known Member
First Name
Dave
Joined
Sep 14, 2024
Threads
13
Messages
508
Reaction score
1,489
Location
Prescott AZ
Vehicle(s)
2022 Ford Ranger XLT FX4, 2014 Jeep Wrangler JK
Occupation
Retired
Step 7 worked for me. I know it says it shouldn't be required but... it was for me.
Hmm...I will try that. Annoying to hit the buttons every time. Support was useless. Were did you get power from?
 

Colo_Ranger

Well-Known Member
Joined
Apr 19, 2021
Threads
49
Messages
3,796
Reaction score
12,891
Location
Colorado
Vehicle(s)
2021 Ford Ranger XLT FX4
Vehicle Showcase
1
Hmm...I will try that. Annoying to hit the buttons every time. Support was useless.

Agreed - The only time I have to hit the buttons is if I use remote start. Even then, it will kick on after 5-8 minutes. Startled the snot out of me when I forgot.
 
OP
OP
dozxab

dozxab

Well-Known Member
First Name
Dave
Joined
Sep 14, 2024
Threads
13
Messages
508
Reaction score
1,489
Location
Prescott AZ
Vehicle(s)
2022 Ford Ranger XLT FX4, 2014 Jeep Wrangler JK
Occupation
Retired
Step 7 worked for me. I know it says it shouldn't be required but... it was for me.
Just wired it this morning. That did the trick. Thank you!
 
 








Top