Search results

Forgot to say I had the TSB done with the rear shimming and it helped but still there. Dealer said “well it helped but its still there so you will have to live with it till Ford comes up with something else to try”

So yesterday I did a little shimming of the support bearing starting with an 1/8” and moving up an 1/16 at a time. But after doing just an 1/8 it was noticeable difference. And just to make sure my mind was not playing tricks on me I removed them and drove it and yes big improvement..so anyway I...

2021 lariat I have 10 each side and there not plugged :rolleyes: now I have another thing to bitch about when goes back again next week..

I know its not street legal but i I would want to take it around the block a few time before I put it up there.

Yes please count me in also..

Can you explain that a little better?

The latest I got from Jimmy::

In ACM there is a “Service Idle” that from what I found out is that the key fob must be in the truck to shift out of park. Anyone enable that? Seems like a good idea. And one other thing, where can if possible can you stop the lights in the dash when you open the door.. T

In the racing world they drill a very small hole in the top of the piston to the back side of the top ring land. The compression puts pressure in that hole and forces the ring against the cyd wall.. Not sure if ranger has them holes or not…

I got some overtime coming up and a TW drive shaft is going to be my next purchase..

I got an alignment today and they could not get the caster inspec but camber is good. Now Icon says that the cantrol arm will fix the caster issue when lifting front end. Now I only did a 2” level kit in the front.. anyone else have this issue. Drives straight and steering wheel is straight and...

So I stoped at my local repair shop and I have given them most of my business over the years and wanted an appointment for an alignment on my ranger that I did the 2” level on the front and also installed the Icon upper A frames.. Guy in the office told me that they do not do any work on...

Just asking if you went with factory spec’s for alignment? Not sure why you may want to change them but only thing I did so far is a 2” front leveling kit and Icon UCA’s. 2021 lariat FX4 Thanks guys

I did the left side first and was a bit of a bitch with the ground wires in the way of the bracket. I also used a ratchet strap to hold the spindle in place..But got threw that part and got the bracket in then the A arm in was the next part as I could not get the A arm over the bracket so I...

Icon has confirmed that the instructions for steel spindles is the same as aluminum spindles..

Just got them for the steel spindles and no instructions in the box or torque specs.. Anyone here have any tips on the replacement and torque specs? Thanks

Ok trying to rap my head around this and understand the concept. Are the check valves an add on to the UPR duel catch can or does it come with it? And where are they added.

Thanks , ordered them and I will have them tomorrow..

Thanks

There are a lot of center supports out there (goggle it) and finding the one that has the size and dimensions that will fit is the key. I’m going with a one piece as soon as I annoy the crap out of the dealer and Ford customer service..