Search results

Amp power steps are on there already. Look a little closer in the picture or blow it up and you’ll see them :-)

Hi, I just installed a BDS 6” lift. I had a 3 inch 2.5 Fox on there with 34 inch tires prior. 34’s Nitto Grappler’s are on there right now………… HATE THEM. Have them (38’s) on my wife’s Jeep also and all 10 tires ( 34’s & 38’s ) started cracking pretty bad at about 1 year old……….. I believe I am...

I remember back in the 70s you could buy the refill rubber on a roll and cut it to the length you need inside the auto parts store.

Sure seems that way….. I hated buying a expensive set like around $75 and then when I first use them on the same day, they seem like they’re rock hard plastic. What a pisser!!!

In my book they get points for trying!

I wash and clean my wipers every two weeks however some of us do not have a choice…. We have to leave our car sitting in the sun every day. I know the rubber wipers do not like that……..

Ordered. Tuesday arrival. Thanks again! Like I said, I was having bad luck picking them myself from medium price to a expensive price, so I figure somebody else might have better luck than me…..lol. Thanks again.

Same problem with our Jeep Wrangler. I bought at least three different sets (cheap ones from AutoZone, but more expensive ones from AutoZone and different brands) that seem to last about five months and then I went back to the factory Jeep wipers which lasted over two years. I’m going to give...

Have you ever tried the elite ones? Trico’s Silicone ceramic? Or do you have a opinion about those? Thanks!

2023 Ranger…. I live in Southern California. Is there any particular brand of windshield wiper that is better than the rest? Most likely I will hit up AutoZone parts store.Thank you. *********Update******** it is real interesting after reading three pages of replies, and thank you to...

Here are some of the cuts that are needed….. if you are squeamish about cutting into your frame, this lift is not for you :)

Please follow directions below………

BDS 6-8” lift……

Sooooo i cut it off. Now i need to grind it down and make it look really pretty, deburr it and paint it.

Even though the Ranger is jacked up high enough, I was in the awkward position that I could not hit the cast-iron taper part hard enough……. Had…. 3.5” Fox 2.5. Going to BDS 6-8” Fox 2.5 and 40’s.

CANCEL request……………… went back out and beat on it some more with a dead blow hammer against the cast-iron tapered area and it popped right off. Thank you.

In the process of removing the lower ball joint. Tried putting a aluminum block underneath and hitting it with a dead blow hammer, also tried banging on the cast-iron tapered area to see if the shock of it would pop it off. I can do go to AutoZone and get a ball joint puller but last time I was...

8” & 37’s Or Stay On Da Porch…….

I myself have them also. They need to be adjusted correctly or they were never go up on both ends all the way.