ready for ecipse viewing and robot rocking... now for someone to put a 5g ranger in the pic lol.
Nicely done - looks great!I removed my rear seats. Or atleast my friend did. We put alot of sound deadening material on the back panel to stop the noise, we used 1/2” plywood for both back panels and the floor and just cut holes for the cubbys. Screwed everything to the original seat bolt holes. We are still trying to figure out how to get the seat belt warning light cleared without leaving the seatbelts plugged in. If you guys know please tell.
.I expected the crash bars. Have them already just not installed. i didnt expect them to touch the crash bar frame. so i may need some spacers for the front or wheels with a different off set. the budget friendly route is spacers. the safer route is wheels. the 33s look smaller than i thought they would. at first i thought they put on 265 70 17s again. no verdict on the new rubber yet as I have only made about 20 miles on them. no loss in go power and the ride is a bit softer. The coopers have a softer rubber than the ko2. i assume they will be better in loose dirt and mud but not as good on rock, sand, mixed trails. we shall see.
Where's Dave?Quick trip to visit the FIL and pick up a few things at Home Depot. Saw this spectacular parking job in the curb side pick-up area. He took up three of the available spots and wasn’t even there for curb side pick-up - he was in the store.
Jeeple- pffft
