Removing factory rubber floor mats

[MarcS]

How in the world do I remove the round rubber “buttons” that hold my factory floormats down to the carpet. I just want to remove them to clean and put them back. It looks like a rubber button, but its not. I don’t want to pry it up. The (very thin!) rubber mats came with my 22 ranger XLT.

Sponsored

 

[seano3ca]

lift gently right at the grommet while pressing the center bit down. You just don't want to pull the pins out of the carpet.

 

[Davidjc]

How in the world do I remove the round rubber “buttons” that hold my factory floormats down to the carpet. I just want to remove them to clean and put them back. It looks like a rubber button, but its not. I don’t want to pry it up. The (very thin!) rubber mats came with my 22 ranger XLT.

Pull it

 

[12Bravo20]

lift gently right at the grommet while pressing the center bit down. You just don't want to pull the pins out of the carpet.

What he said.

I pulled the Ford slush mats out right away since I already had a set of Husky X-Act fit liners.

 

[DanielPierre]

Slide 4-fingers underneath the mat, and from the side of the mat towards the center of the button while holding the center-button down with your thumb and lift up at an angle. Repeat this for the second button.

 

[MountainGoat]

Don't listen to these guys saying crazy things like "pull it". I did that and the whole floor panel came up, to the point where I could see pavement from inside the cab. Take it to the dealer. They have a special floormat puller tool they use.

 

[RangerTX]

Pull it

It think you mean tug it...

Sponsored