Stranger_ranger
Well-Known Member
- Thread starter
- #1
I replaced my crash bars with the BDS low profile beams and worked like a charm. Absolutely no rubbing now!
The process wasn’t too bad to be honest. I pulled the bumper forward instead of cutting the crash bar. I was vaguely familiar with the pieces in the front since I’d installed the lower hex grill insert and removed the valance to plasti dip previously. I can’t say for certain which process is easier whether removing the bumper or cutting the crash bar, but I can say the bumper process is tedious but not that bad.
I attached a before and after pic of the beam with my tire at full lock.
The process wasn’t too bad to be honest. I pulled the bumper forward instead of cutting the crash bar. I was vaguely familiar with the pieces in the front since I’d installed the lower hex grill insert and removed the valance to plasti dip previously. I can’t say for certain which process is easier whether removing the bumper or cutting the crash bar, but I can say the bumper process is tedious but not that bad.
I attached a before and after pic of the beam with my tire at full lock.
Sponsored
