ranchero
Member
- Thread starter
- #1
Builtright MOLLE bed side panels--4 pieces in total plus hardware--in very good condition.
$200 firm plus shipping if you're outside the DMV area. Best guess, in CONUS shipping is probably about $40. I'll wrap and pack carefully for shipment, but I'd prefer to sell locally if possible.
These now list for $590 (wow.) on the Builtright website: https://builtrightind.com/products/bedside-rack-molle-truck-bed-panel-system-ford-ranger
The panels were on my truck for four years and they withstood near-constant use without any signs of wear beyond a few very small and minor scuffs (in the couple places where a scuff got through the powder coat to bare metal, I cleaned, primed, and touched up with enamel black to prevent rust). A hi-lift jack and full 4-gallon water tank hung from these for years and there's no sign of bending or wear from the weight.
I replaced one mounting screw (visible in photo if you zoom in), since I lost the original when removing the panels from the truck. The new screw uses the same hex size as the original screws.
I'm planning to cross-list these on Facebook Marketplace, but preference will go to forum members.
$200 firm plus shipping if you're outside the DMV area. Best guess, in CONUS shipping is probably about $40. I'll wrap and pack carefully for shipment, but I'd prefer to sell locally if possible.
These now list for $590 (wow.) on the Builtright website: https://builtrightind.com/products/bedside-rack-molle-truck-bed-panel-system-ford-ranger
The panels were on my truck for four years and they withstood near-constant use without any signs of wear beyond a few very small and minor scuffs (in the couple places where a scuff got through the powder coat to bare metal, I cleaned, primed, and touched up with enamel black to prevent rust). A hi-lift jack and full 4-gallon water tank hung from these for years and there's no sign of bending or wear from the weight.
I replaced one mounting screw (visible in photo if you zoom in), since I lost the original when removing the panels from the truck. The new screw uses the same hex size as the original screws.
I'm planning to cross-list these on Facebook Marketplace, but preference will go to forum members.
Sponsored
