wiring

I bought a SmartCap used and I didn't realize until I got home from the VERY long drive that the harness for the lights was missing. I know there are a lot of different harnesses available for purchase that can solve this but I would like to try and solve this in a more cost effective manner...

Hey Ranger fans its The_Stranger_Ranger, I’m wiring up four Nilight 5.7 Inch Round 50W LED Driving Lights to my 2022 Ford Ranger and want to combine the wires into a single 30A rocker switch to control all of them. Each light comes with its own relay, fuse, and 6AWG DT connector wiring...

Hoping to poll the audience to assist in identifying a broken cap on the top of my Fuse and Relay Center Junction Panel Box. I have scoured Ford Parts and investigated every diagram I can get my hands on and still have been unable to identify this broken cap. Location reference: Mine: It's...

Ok, so I’m definitely not an electrician but have previously done some auto electrical work. I cannot for the life of me figure out how to wire the set up I’m wanting. I bought these lights (just prefer them over the strips) https://a.co/d/e2dqtpY and I also ordered this switch (didn’t like...

I recently got the DSS Rigid lights and the instructions are not good when it gets to the wiring. It comes with a switch but I’d would like to use the Tremor switches but not sure how to hook them up. Do I hook everything up to the battery? Where does that black box go? Is the negative hooked to...

I bought a Rexing V1 4K dash with the hard wire kit. I eventually got all the wiring hidden, found which fuse slots to use, but can't find a way to convert the wiring's standard fuse size to the micro size in the fuse box. Even Ford parts didn't have anything I can use. Any suggestions or...

(Posting here as it has some Tremor-specific questions regarding the Aux switches, but can post in the Lighting subforum if more appropriate) My old man picked up a Tremor and I thought as a birthday gift I'd buy/install some bed lighting for it. He's got a rolltop tonneau cover so I assume...

I have searched the forums, but have not seen too much detail around the install of the SP9100 into the Rangers. If I missed it, please point me to the thread(s). Anyone have detailed memories of how you installed yours? What accessories did you connect and how was the process for tapping...

So I have a weird issue. I have a set of electronic running boards made by Pegasus4x4 based in England. I have these not by choice but because the individuals that had the truck before me had ordered them but they were left to me to install if I wanted them. Well I went through the process of...

Hi All. I tried searching and scouring the posts to find an answer but came up with nothing that was straight forward so I am hoping someone can help me out. I have a 2019 XLT supercrew with 302A package but no tow package. It looks like on my bumper there is a empty hole with a flip-up cap...

Hello all, I didn't know if I should post this in electronics or Interior Mods. I know where I want to install my CB, the problem is that I don't know how to remove the center console to hide the wiring. My previous vehicle was fairly easy but not with the ranger. Has anyone removed the...

HI there people. I need to pass an RG58 coaxial cable (about 5 mm outside diameter) from the outside of bed to the inside of the cab. The coaxial cable will be for the antenna of a 2 way radio. Any ideas on how to do this? Are there existing grommets I can use on the back of the cab? Should...

I transferred my brake controller from my Grand Cherokee over to the Ranger today. Super easy, although why couldn't Ford just put a freaking plug on the end of the wires for us. Im disappointed in this. Pulled the lower driver kick panel and saw the 3 wires coming through the firewall. The...

Whats the best way to get switched power for additional accessories? While I'm not totally opposed to cutting wires - I'd prefer to avoid it if possible.