Search results

Hook the loop on the damper with the hook on the tip of the knitting needle. Pull it out and keep the loop straight up and down. Get the glove box part way closed. to a position where the loop will be able to reach its attachment post on the side of the glove box. You'll probably need a light...

Thank you to the person who mentioned using spouse's knitting needle to hook damper loop to reinstall to post on glove box after changing cabin air filter. I fashioned a hook from a coat hanger and it worked great. Don't remember if I read it on this forum or somewhere else, but THANK YOU 100x...

No laughing. You know Wiley Coyote is under there somewhere.

Also, does it do anything bad or something I might not expect or need to pay attention? Thanks

2020 Ranger coming close to end of factory warranty. Over the last few months, I've had different problems with the display functioning. Would not illuminate at all, would illuminate but very faded and buttons would not work, would illuminate perfectly but buttons not work. It would always...

Yup, the cussing did it perfectly, but now how do I get the blue air out of the cab? Cord is not long enough to reach post when glovebox is open. What a stupid design. Thanks all for the feedback and encouragement!

Anyone come up with a trick to easily reattach glovebox damper after cabin air filter replacement? My little trained monkey is on strike. Thanks

I have 2020 XLT 2wd extended cab with factory tow package, 12000 miles. I was quoted $25, 28, 31K by 3 different places, Carmax, Carvana, and dealer. So the short answer is yes. You may well be able to sell yours for more than you paid, especially with such a high end model.....Good luck!

Thanks for all the feedback. Here's what I've gathered from this thread and the www: I would only use the Ford controller (much to my chagrin) to ensure interface with all functions, and its install is more complicated than after-market controllers. The controller itself can be had for $275-300...

The Red Arc is not quite the same although Red Arc manufactures the Ford OEM brake controllers. The Ford has an additional module for a couple of functions that the Red Arc does not have. The Ford OEM is the only brake controller approved by Ford. If you hunt around on the www, you can find the...

I have a 2020 Ranger with factory tow package. Had it in for a couple of recalls this AM and asked for a quote to furnish and install the Ford VKB3Z-2C006-A trailer brake controller. I couldn't believe it when he said $989+tax. What have others been quoted?

I have a 2020 Ranger equipped with tow package. I want to install the FORD OEM trailer brake controller. I am able to locate/isolate the 4 wires for the trailer brake controller. Before I attempt this I've googled plenty of stuff. It appears from all the videos I've seen that half show the...

I checked all the videos I could find and the installation looks doable to me, but I have a few questions for anyone who has already done this job, and I really appreciate your feedback. I found the 4 truck wires without too much trouble but man are they short. To find them was one thing but...

OP, take a bow, and report immediately to Ford tech writing department to put your skills to good use!

I'm planning to install a proportional brake controller. I'm not a wire guy but it looks to be within my capability. I've located the 4 brake controller wires in the truck (could they make them any shorter?). I plan to use an adapter harness between the controller and truck wires. Can anyone...

I'm planning to install a proportional brake controller. I'm not a wire guy but it looks to be within my capability. I've located the 4 brake controller wires in the truck (could they make them any shorter?). I plan to use an adapter harness between the controller and truck wires. Can anyone...