A little slow with the replys. The exhaust is really simple to install. Its a direct bolt on. So no welding or anything. Took me about 2-3 hours to do, but a large portion of that time was fiddling with the alignment of the exhaust tips so that they were even in spacing from each other.
And...
Sorry, been away from the computer a while. I can try to get a picture later this evening for you. They are definitely more of a flood light. I would not use these driving as they arent "focused" and you would probably blind others. I use them for camping and they work great for that.
I have the stock nav option, so I just use the dash unit. I listen to music and podcasts through my phone, so having all that and nav done through the in dash screen is nice, but not a huge inconvenience to connect through bluetooth for audio only.
Has anybody ran into the issue where AA disconnects after the phone reaches 100% charge. My AA works great in my ranger but always disconnects and will not reconnect after the battery reaches full charge. I just stopped using it and connect through blue tooth now cause I couldnt figure out why...
This was the amount of oil pulled out after the first 1000 miles after installing a oil catch can. Standard size solo cup for reference. Catch can was roughly half full.
The easiest way to do it is to get a hair dryer or a heat gun, and just heat it up. Move the heat source slowly back and forth across the decal, about 8 inches or so away for a few minutes. The idea is you are heating up the glue that holds on the sticker. If you are too hot, or too close, or...
The install was extremely straight forward. The instructions supplied are pretty great as well. I changed up the included wiring harness so it tapped into the fog lights for the signal to turn them on. That way the factory fog light switch turns on all the fog lights and the LED lights. This...
Im interested in these as well but am curious how they would look on the ranger. Not sure how far up the door sill on the side they go and if i would like that look.
I think so. The kit is relatively cheap and comes with everything you need. I like the "stealth" look of this kit how it sits inside the bumper slots. I just finished the install this morning so I havent seen it at night yet to see how bright they are. I do very mild offroading to get to...
ITS ALIVE! Thank you so much for the help! I always get nervous doing electrical things but this was way easier than i was building it up to be in my mind.
Installed the rough country 6in LED light bars in the bumper and went ahead and painted the front plastic piece black as well while i had the bumper off. Waiting for the sun to set later to see how much light these bars throw out, but they definitely look really bright.
Heres my sheet good hauling setup. Notched out the boards so that they "lock" into each other. The front "header" board has some clasp latches that latch onto the long board to keep things from sliding fore and aft. The length is a full 8 feet to fully support sheet goods. And 2x8s are...