Search results

Let's trade silver rangers.

Well I suppose can order this as well. Don't have a dog so I'll have to order an Asian looking female passenger and feel slightly racist as I do it instead.

Double post time. After reading the seat thread, came up with an idea. Instant difference. Don't feel like im sinking into the seat. Gonna start looking for more permanent materials to use instead of a abs plastic divider from a storage tote...

I'm very interested in this, since I've had similar experience sitting in my passenger seat.

After I pulled the cowls off 1) Replaced the cheap foam gasket with thicker 3M foam tape. 2) Used a mallet to bend the lower cowl lips(the metal half) upward to take up the gap between it and the plastic cowls 3) Used better fittings push pin rivets. 4) Ran a thin bead of RTV 5) Added edge...

Cleaned windshield/wipers. Inspected catch can. Discovered my cowl leak repair stopped working, lol. Least my over priced engine cover is doing it's job... You can see where the water enters and runs down.

Damn less than me. Edit: derp derp can't read.

Dealership over inflated them, I aired them down about 3k miles ago. Im sure I can get another 10k out as long as i keep up with rotations.

I'm at 14k miles and my duelrs are already pretty close to those wear bars.

I usually avoid companies that have obvious bias toward a certain brand, more so if it's not for the brand of vehicle I'm shopping for. If they had a wider range of products not for toyota, I'd take a gander.

As an uncle, that babysat once or twice I can only relate to... "Shit, where the hell did he/she run off to? OMFG WHERE THE ****" Then scream a little.

Built ford tough. Oh hang on, let me glue this trim piece back on.

I only notice cause I have poor circulation in my feet and gets cold down there with these single digit temps. Otherwise same for my upper vents; Plenty of flow especially after swapping for a washable cotton filter. Wonder if I can repurpose the rear-seating floor vents...

Stop blasting china like you don't own anything made there lmao. Blame the USA companies for requesting cheapest materials possible. ANYWAY, Made in dayton ohio for anyone that cares. Those are some nice ass wheels(XO2). Maybe I'll skim their catalog after my tax refund.

I've never had much air flow in my floor vents since getting the truck. Is this a poor design or have I been unknowingly ignoring a warranty claim?

Thawed out my oil catch can and lines... God winter is great. (Sarcasm) Yes, got myself a disc shaped ice chunk.

The low mileages might be making people skeptical. I would probably be curious/cautious why such a like-new used, low milage vehicle is on the lot. Before ordering my 22, I skipped over several 2019 models cause they all had under 8k on them... Just seemed weird people were trading them in so...

-13 here right now. "Why don't you ever enjoy the new year" Ohh I Dunno, maybe cause in a week or so it'll be in the single and negative digits?

The gas pedal is plastic and is kind of thin so I would definitely make sure to drill pilot holes first. Brake pedal don't remember. My pedal cover kept coming off so I superglued it in place so I can't just take it off to check, but I believe the brake pedal is metal.

Took a test drive to check for any issues with my less than professional install of new lines for my catch can. Engine kind of bogged down, took a bit to hit 110mph Did another WOT pull, accelerated normally but sounded weird. Burning Oil/Rubber smell form turbo charger area. No leaks...