Search results

Good question, my local dealer said they didn't care when I asked about the trans pan, I haven't put it on yet but I was curious, but, I used to work there 23 years ago, I should ask about if that's for anyone. It used to be the simple, common type accessories were never a problem, only if it...

Actually now that I'm stuck again waiting on parts, I'm going to get out some of the updated sticks, I will PM those of you and get some measurements!

I hope it warms up enough! Thank you very much! Wow, #94, how cool, I'm up to 114 so far, when I got to 100, I had to PM the OP and thank him for opening up this rabbit hole :like: I really have to appreciate the members here, the positive input and encouragement has been great, I wouldn't...

I hear you on the back thing, what I would give for a hoist :facepalm: Get a clean bucket and pop the plug, walk away for a bit, get a new sealing washer/O ring, pump or pour the fluid back in, at least now you can do that standing up. It's not bad luck, it's just a bad plug seal!

This is the Mishimoto one, good draining.

You need a little angle, either a funnel that can bend a little, or a short section of hose.

Some thin wall 3/8 hose will fit, almost any 1/4 hose will fit.

Yes, as mentioned above, the dipstick hose can withstand 300+ PSI. For filling a flexible funnel, or a smaller rigid funnel with a piece of hose, even one of those hand pumps will work.

That's great you guys?

That looks to be really low! the hole can be tricky, it goes down at an angle and there is a step part way down, I will rock the stick at bottom just to feel if it's full seated. Either way, now you will be able to know where you are at and adjust accordingly. That fluid does look dark, the...

It should not be a problem shipping to Canada?

Don't try to go by the cold number after it's been sitting, it can vary, check it hot, add as needed. Glad it was a breeze? Thank you very much!

This is the list, you just put yourself on? Thanks, for your interest!

For years it was a broad range, about 3/4"-1" was the crosshatch area that you would not add if in that range. Now with the shorter stick the range has narrowed to 4-5 which is .313" of an inch area. So it still is a range, it is less than the old dipstick range, but still within a range. My...

Great, thank you very much! I finally found some proper fitting caps to ship it with, no more sealing plastic film. (that looks ugly :LOL:)

Those are the thickest at .125 in the mailer category, the next step up is the .250 for shipping steel pipe and such. Yes, the shipping has become more of a challenge than getting the replacement sticks :facepalm:

That's interesting, I priced uline before, they are usually one of the more expensive, in price and shipping, I just did a trial checkout, not that bad, shipping was only $24. I need to hit Box City and see if they have something similar, pick up a few of them, I'm not sure I should drop $136...

Those are what I will probably try next, but I do have to get the 36" version?

No, not you, most are fine, I have just lost stuff completely, or it never shows any tracking progress and then it's delivered.

I have had poor luck with USPS, but that is worth a try, especially now that I'm having poor luck with UPS, thanks!!