It need the following, and I'm local to LI.
BUMPER COVER SPACER PANEL (LOWER) Tow package 2
KB3Z17F774A
KB3Z17F774B
Somebody ran into my rear bumper, and the collision shop replaced with the non-towing trim. Now the hitch bolt doesn't fit.
I purchased my 2020 XLT FX4 and found the ride fine for the first couple of thousand miles. After 3K miles it became very bouncy and felt uncontrollable. I took the replace the rear shocks route with the Bilstein 5100. Huge difference in ride and control. No more pendulum rocking. I will...
I installed the rear Bilstein 5100 on my FX4 this evening. After reading the threads on the various difficulties on install, I decided to plan the work out a bit. My plan worked, only 30 minutes to install both in my driveway, solo.
Step 1. Measure the distance between the shock top both...
Why not just replace the bulbs with bright LEDs? I did it and they work great and are certainly brighter than the OEM F-150 unit and likely far cheaper.
Test freshly after installation with 3 inches of heavy rain and wind here on the coast. 98% dry. Some water in the cab side corners where the large gap in the bed exists. I'll need to do what everyone has done, and place some flashing to fill that gap. Additionally, a few drops at the tail...
Fresh from the lot three weeks ago. Since I installed the OEM Trailer Hitch, Brake Controller, Leer HM350 hard tonneau cover, and now winter tires. Certainly not a popular color, which is a good thing. ;)
Quick addition for those buying / installing the Leer 350.
1. They have added some shims to the fasteners to ensure a tight fit. The channel is not even, so don't be surprised if you are using different combinations be of shims. The section nearest the cab was wider than by the tail gate on...
For any of the folks with the Leer HF350 Tonneau cover, do you have the factory bed liner and if so any special consideration for installation? I'm narrowing the field and so far the HF350 looks right. Just checking for gotchas. ;)
For those with Forscan and the Factory Tow Package, can you tell me what your setting is in APIM & IPC for Trailer? I installed the Factory/Redarc unit with the Factory Hitch. However, when I look at Forscan I see a few of the settings set to disable. This may be correct. I'm wondering if...