Search results

Folks I’m going to do a transmission fluid service by pumping all I can out of the fill port and replacing the exact volume. I have been researching the Valvoline ULV and would like to refill the transmission with it however since there will still be a volume of the OEM fluid I can’t get out I’m...

Well my Ranger sprouted a nice big head of muffler hair. My wife took it to have our snow tires put on in preparation for trip to Revelstoke BC and came home with the packing blowing out the tail pipe. Do any of you exhaust experts know if the resonator that's down stream of the muffler has any...

Well the latest curve ball from the Ranger has me scratching my head. Due to a miss fire at idle and concerns of water in the plug wells I decided to change the plugs at just over 30k. Hole #2 and #3 were full of oil. It was at least 1/4in up on the boot and puddled up around the plug when I...

Just drove our Ranger for the first time since early summer. Instantly heard the wear indicates on the rear brakes. My wife has been driving the truck occasionally this summer while I have been gone with my work truck, but not a lot of miles. I did a full inspection of the truck this spring to...

Does anyone by chance have measurements from center of hub to bottom of fender on a stock height FX4 front and rear? I was in a rush when installing my OME leaf springs and Fox 2.5s and didn't get any pre lift measurements. I'm trying to establish how much lift I ended up with as the rear is...

Just finished installing my Fox 2.5s. After I got the tires back on I was testing clearances and sure enough at full lock the tires hit the fitting coming off the resi. The orientation of the fittings coming off the resi doesn't seem like it can be changed or in other words i don't see how you...

Well the Ranger just delivered a low blow. Discovered an oil leak while doing an oil filter change in preparation for a 15 hour drive for our holiday trip we have been planning for 6 months. Im having trouble finding the source of the leak. From what I can tell it definitely drivers side, rear...

Seems like a lot of Glock guys drive fords. Any other Sig fans out there that like to pack metal framed hammer fired classic P series around in their rangers ?

I have seen a few threads about people who suffered damages to their rangers from mice rats or squirrels chewing on the wiring harnesses or even getting in the cab/duct work. I’m on a new job re claiming 30+ acres of pastures lands and mowing down all the black berries that have overgrown the...

Has anyone else installed the Fox 2.5 rear piggyback shocks? I am aware that the shock orientation does not matter as far as performance and function. I like to run my rear shocks with the shafts down and the bodies up for all the typical reasons. In the brief install instructions from Fox they...

Just did my first little road trip with the new Ranger towing my snowmobile trailer. The trailer is an 18ft enclosed all aluminum two-place snowmobile trailer with a V nose running on tandem torsion axles. Fully loaded with two sleds, fuel, and gear I estimate the trailer to weigh in at just...

Can anyone confirm that the upper ball joint stud taper on the Icon DJ UCA's will work with the cast steel spindles found on later 2020 builds ? I am starting to make some moves on my suspension buildout and ran into some mixed messages while trying to decide on what UCA's I want to go with...