Search results

We recently experienced a cold snap and I had to air up each tire by 3 PSI. As I did each tire, I checked the Ranger's tire display and it matched my gauge exactly. I did not have to move the truck, in Accessory Mode , the TPMS system updated the Ranger's display within a minute of adding air...

Anthony, Before you spend any cash on the relearn tool, did you try temporarily changing the pressure on 1 tire and checking the display to see if it matches position? I swapped my original wheels and tires with a 2nd complete set of Ranger OEM wheels, Winter tires, and OEM TPMS sensors, and...

Yes, I used FUZ-14489-A successfully along with the "D" harness.. Plug and play.

You can also check Kelly Blue Book. https://www.kbb.com/instant-cash-offer/#/ I had 3 dealers calling me within a few hours, and got $500 over the instant cash offer (which was much better than the Ford dealer offered as trade for my Ranger).

It's well covered here ... https://www.ranger5g.com/forum/threads/safety-recall-19s43-select-2019-my-ranger-vehicles-rear-lamps-issue.5182/

I was able to load successfully this morning. I just checked the file names and sizes and they match exactly Josh's from the first post in this thread. If you get your stick to match his, you should be good to go!

That is likely one of your problems, In addition I don't see the license file in the SyncMyRide folder (XXX-14G424-XX.TAR.GZ ) .. That's the "Error 05 " message... One last thing, its best to use a 32gb USB 3.0 stick as a 16gb is cutting it close..

Glad to help!

Link to Chevron's site with ILSAC GF-6 details...

Thanks! This confirms that I can use TPMS42 for my 2nd set of wheels..

Perhaps the Rangers’s TPMS receiver is dual frequency?

Matt, Were you able to verify the TPMS sensor frequency? Rock Auto also shows a 315MhZ TPMS42 if you look under 2019 Ranger ->"Wheel"-> "Valve Stem Cap". Thanks! JM

The holes will be 4 inches in from the bedcap on each side. See diagram 3 in this link.. https://truxedo.com/images/Install%20Guides/1118322_InstrRangerBulkheadAdapterInstallationREVC.pdf Ignore the comment about drilling (this only applies if you have a drop in liner). You should be able to...

In Northern climates, it's a good idea to replace the dealer supplied generic steel screws with stainless hardware to avoid the aluminum license plate causing the fasteners to rust.

Confirmed. This is the exact setup I added to my Ranger.

For carrying in the bed (your least expensive option)....... If you use the Yakima Longarm as a bed extender, it will give you an additional 2 1/2 feet past your tailgate with 4 1/2 feet of canoe hanging off the back of it. I have this setup on my Ranger - only difference is that I have the...

Unfortunately not ...

Moderator (Rangerdanger) estimated 150....

The reason many of us replied to be on this list is because Panda was offering a group buy. See post #4 of this thread.