Search results

Nice idea. Just might do that. Thanks. What was the connector PN for the female (?) side that you made the pigtail with (as I can't find that either. I'm not a car guy so I don't know all the ins and outs of connector types/names)?

Would have done that, but for two reasons. First, I couldn't find the connector type listed anywhere. So I gave up and went with a splice. And given that I needed to get the truck out on the road I didn't want to give the local police/state troopers an easy ticket while I waited on the part...

No shame in that. You're doing just what I did. I was going to start a new thread on this topic because it took me over two weeks to sort through all the advice. Even Leer makes it more difficult than it needs to be. I'm pretty sure there's no difference in wiring between yours and mine. YMMV...

I don't have that dedicated wire in my 2023, but it turned out to be very simple wiring in the CHMSL (if that's where you're heading). In fact, just did the wiring hookup yesterday. Splice off the bed power point connector (on frame behind the left rear tire; a simple 2-wire connector) for the...

Excellent suggestion. Thank you. I tapped into this to power/ground a switched-controlled dome light in my Leer topper and ground the topper's CHMSL. Works like a charm. Cheers.

I appreciate the reply. Thank you for the info. I saw a different post about removing the console tray and noted the OP had the same problem as I did (which prompted my ask): the front edge seems to be held in place via a hinge (at least that's what the OP and I encountered). So prying it up...

I bumped another older thread about a week ago on a similar topic and got no response (it was my first post here on Ranger5G). So I'll bump this one and hope to get an answer. If not, off to create a new thread. Here's the problem: I can't seem to find anything in the shop manual that addresses...

Bumping this older thread (my first post). I can't seem to find anything in the shop manual that addresses removing the upfitter switch console because I'm looking to do the same thing (drill holes in the back for a GPS mount). I tried starting at the front and almost made a mess of it as the...