Yikes! I've got an early build '19 (1/22/19) bought in March '19. I reported the late shifting on my first dealer service in Sept, but it wasn't recorded on the service tag. I did notice a slight improvement after that, but at this point I have no idea if they did anything about it. It doesn't...
Oddly enough, on a 80mile round trip this morning, my driving & idling voltages were about 14.2 and 13.6 respectively; never climbed over 14.5v. When I start after sitting for a while the voltage goes right to 14.2 and then drops to around 13.2. I did reset the BMS to 70% prior my trip this...
The amount of useful information in these threads and the commitment to follow through and resolution is remarkable. Everytime I explore an issue or try to suss out an answer, I turn to this forum and find a masterclass on suspension, tires, electrical and everything Ranger. I didn't want to...
I just ran into this thread after finding the tail light theft threads: I had no idea until this week tail light theft was a thing. So now I'm paranoid. This of course got me thinking about tailgate locks and such, and voila! I found this thread.
It's great how this community is so open and...
Agreed. I'm sure the electronics for the strip light are probably the lowest quality available, so even 1 volt out of range might be enough to cause problems. I didn't get a chance to check the voltage to the turn signals today. I'm home all morning tomorrow so I'll take the time to check it...
Good questions. These LEDs are an add-on, not replacements and they're wired in parallel with the OEM signals and draw approx .6amps. Total circuit draw including the <2amp OEM bulbs is less than 3amps. I thought it might have something to do with the BCM, but so far I haven't found anything in...
I added an LED light strip with sequential LED turn signals to the gap between the hood and the grill/headlights. It's one of those inexpensive stick-on light strips with turn signals built in. The white LED DRL strip definitely adds to front-end visibility, and the sequential turn signals are...
It's an "Appearance Package" that includes 'Magnetic' painted exterior accents: the grille surround, bumpers, fender vent surrounds and wheel-lip moldings and the 17inch wheels. Plus those big stickers that tell the world, "Hey, this guy's sporty!"
Wow, crickets. I'm experiencing the same right now. My truck is completely stock other than a disconnected BMS for a few months. I'm going to do a deeper search of the forum to see if there's any insight on the issue.
EDIT: I found this old post in the FocusFanatics forum:
While it's not as...
I had a Brahma camper shell (molded plastic) on my '87 Nissan Hard Body for 15yrs. It was very tough and super light - less than 100#s - I could slide it off the truck and walk it into to my back yard whenever I wanted to load dirt bikes or anything taller than the shell. Every modern topper...
I use onxOffroad, Avensa, Gaia and GPX Viewer for my moto camping. All fire trails & 2-tracks are shown on all three, onX has great detail when I'm on small, semi/rarely maintained single track trails. I use GPX Viewer to view routes already plotted by others. You've just got to spend the time...
If you didn't already know, aftermarket tint percentages typically refer to Visible Light Transmission, and factory tint percentages usually refer to the percentage of light blocked: a 20% factory tint = 80% VLT; an aftermarket 75% tint usually means 75% Visible Light Transmission (VLT). When...
Hey folks. I picked up my 2WD Super Crew XLT Sport in March '19. Other than the BMS BS, I've been very happy with it. It's been out of basic warranty for a while now, so I want to start personalizing it a bit. I've been following a few build threads and there are some serious goings on here! As...