Search results

Good to know I have ARB skid plates as well ?

Lucky you have access to a lift and shop. Thanks for the pictures should help with my installation. A question about how low it hangs below frame rails? Before I install mine I plan having the exterior bottom portion covered in a spray on bed liner material to help with protection on trial from...

Glad you got it installed. ?looks close to AC line did you bent it out of the way or loosen bolt and adjust to make room

Ok just checking I’d Definitely recommend 1/2” drive like Mike said 3/8” flex’s a lot.

Just to confirm if you’re under the truck you are pushing wrench towards front of truck to loose? it’s opposite because youre coming from below. Just checking know some members were having trouble with that. But if I recall a member here used an impact to loosen cap he had trouble as well.

Hi Mike I’m interested in updated stick #33 thanks

This is the standard PPE pan it has a slightly lower area near drain plug to allow proper drainage. FYI

Not sure if it really increases capacity by much. It’s made more for off-roading applications It’s stronger and won’t crack or break off if I hit a rock on the trail. If you do some research I’m pretty sure Bronco cover will work. Not sure 100% but I believe this rear end is used on multiple...

There’s also PPE OR mishimoto just came out with one too. Get cooling fins and drain plug. Might be a little pricey but you get what you pay for

Go with ARB I did has a drain plug and dipstick. The brake line does get in the way of dipstick but it still can be used to measure and fill from hole. I have 2019 with drain plug on housing.

Now, looking at it, it looks like there are four bolts holding the seat in. For those of you who've pulled the seat, does that sound right? peterb Yes just 4 bolts under plastic covers. I think it’s a torx T40. I removed the seat to run wires into cab for side step lights. There’s a grommet...

Received this message today time to change battery. Might as well change original H7 also. Costco here I come.

Mounted 3 small quick fist rubber clamp to plastic trim behind rear seat.(I have deleted rear seat) Holds 4 hiking sticks pretty well. Was just wasted space before. Had to drill holes in plastic trim and a hole in metal behind trim to make room for nuts on back side.

I believe they’re all the same or similar and will do the job. I recently changed my plugs at 62k miles had a cover the whole time no plugs broke off. Thank god!! I used this just to be safe and have used it for years on previous vehicles. As a side note be careful with anti seize if you get...

Still haven't heard from the dealer. I don't know if this is a part shortage or what... Greg It’s in stock on rockauto 52$

Looking at the long range tank and photos it appears that the tank cuts down ground clearance. I know the Transfer Flow did. I agree you do lose some ground clearance maybe 1” below the frame rails. But I don’t plan on doing serious rock crawling with my Ranger only Overlanding/touring maybe...

I looked through the service manuals it wouldn’t load file corrupted. But I found this on another post not sure if it’s accurate.

Hope this helps https://longrangeamerica.com/shop/ford I purchased one when they were first available back in early summer for 1900 no shipping. It was also sent to California even though it says not for sale In California. For those who are concerned with that. Hope to get 500-600 mile range...

Too bad you don’t live in SoCal area I would give you these they’re stock roughly 30k miles. Pulled them out of my 19’ when I upgraded to icon. The stock graveyard is starting to pile up