Search results

I cut out a piece of non slip shelf liner to keep stuff in there from rattling. Steve W

Never heard of them before, not really needed here in S. Louisiana. Steve W

Nice antenna, short! Steve W

The truck, or my truck Steve W

Not Carlos here, but I lived in PR Central Aguirre 1952-62, then Central Coloso 1970-72 A wonderful place, especially Aguirre, en esa epoca! Steve W.

I see some of you guys are like me, emergency rations scattered all over the floorboards. I figure they might come in handy in case I get stuck in a big South Louisiana snow bank! Steve W

Somewhere a Ford car prep employee is looking for that.

NFL mouthguard? Steve W

Two days ago I downloaded the update program from the Ford site on a thumb drive and did the install with the truck running in driveway. I checked on it several times as it was installing, after about 45 min it showed complete, I shut it down for a bit then cranked up and it has been working...

probably so the lightning or flames point in the same direction fwd or aft once they are applied right and left sides. My guess! Steve W

I use 87 octane. usually from the station at Walmart. The truck runs fine (as did the Tacoma before it) in my opinion I don't push it, most of my driving is on rural roads. I have towed my 17' Boston Whaler again no problem. The last couple of months have been very hot so have been running the...

I finally got the Linex Bed job, not available nearby so wound up going to Lafayette, Louisiana. We dropped it off at 8:30 and by noon it was done. I recycled the rubber mat I kept from the Tacoma I traded in, it's not an exact fit but close enough. I wanted to add some tie down points, so...

I can't seem to find them for a supercab, front doors only. No sense in putting deflectors on the half door windows which don't open anyway? Any suggestions Steve W

My windshield is wavy on the curve of the passenger side, I notice it from the drivers seat , my wife has never mentioned it so maybe it doesn't show up from the passenger seat. I don't notice it unless I look for it so I will let it be, don't need the dealer to maybe do a bum job replacing the...

Here is my CZ. 6.35 mm ( .25 cal) It was my Grandma's purse gun! I think it was made mid 1950s Steve W.

I'll be getting a Line-x job on mine in a couple of weeks. I'm not sure what is the best thing to do with the extra threaded holes for the tie down "U" s. In the pictures (blue Ranger) above it looks like they were simply sprayed over, I guess the bolts will clear the threads as they are...

Just enough for a good ShishKebab!

That sounds like it may be the problem, I read the TSB on a past thread just now, mine is a 05-2019 build but I will check with the dealer as the symptoms are similar. Thanks! Steve W.

When I start the truck up in the morning the engine runs very rough, coughing, sputtering, varying rpms everything but stalling altogether. It is jerking as I back out the driveway. The driveway is L shaped, first stage about 150 feet as I back out is rough . Then I drive in fwd about 200 feet...