Search results

Only if your dead inside

Wife just got me mine for an early xmas gift. deff not necessary, offers about as much performance as replacing the grill. also causes the truck to buck a lot, because I will go from wot to off of it everytime I leave a light and giggle like a little kid. :)

Update: fuel smell - dealer says they couldn't locate the smell of fuel and I brought it home and no smell so far. Checked the oil and wasn’t high and smells like oil to me so that goes in the mystery hope it doesnt happen again category. Transfer case - dealer said “found a small amount of...

Thats exactly what mine looked like on the rear pass door i was going back and forth on having it fixed but i figured it would break through eventually and then it would be just a matter of time for water to get in and really start messing it up

FYI. Spacers are gonna make it worse if its the crash bar. i went to a +25mm rim with stock tremor 265’s and ive worn a groove in the plastic cover on the drivers side from when i reverse.

I had a grain of sand or something on the door under the paint that the qc guys at the dealership circled when it came of the truck and then on the rocker where the textured protectant is painted over on the driverside the body shop said it was a chemical reaction due to the under coat not being...

Thanks for the info and advice! w i didn't check the oil before dropping it off but hopefully im not headed down that road. But we will see honestly kinda grateful for the fuel issue at this point or i probably would not have notice the transfer case issue untill something really broke

I drove a bison a while back and while the diesel was a little low on power it was pretty nice

Hahaha fair enough. It really is true though i was looking for another colorado but 2 local dealers had 0 in stock so i stopped next door at ford just to see what they had and they just happen to have a tremor in the right color fresh off the truck

Thanks bud hopefully!

So took the Tremmy to vegas last thursday for the mint 400 and really enjoyed the drive as the truck is pretty darn comfy. Got back late sat and parked her in the garage. Sun morning rolls around and I went to get my stuff out of the truck and the entire garage reeked of fuel. Started looking...

I have the tremor nostrils and i cut the tabs off so they can be attached with vhb pretty easily . I just personally didn't care for the red when its no where else up front but with red tow hooks it could look good

Too many logos on this truck already, last thing i need is giant letters. i think color matched with no oval is the way to go.

When you say cut in half im guessing you split them up the middle like the high clearance bars? Just wondering because since i switched to a +25mm offset the front rubs in reverse on the stock general grabbers. so what ever solution i end up with might as well be future proof since the next...

Magic erasers have no solvent or cleaning chemicals in them its just light wet sanding ive seen it fog plexi really bad, i wouldnt trust it in optical glass. Have you tried alcohol based lens wipes? They should be safe and are pretty effective at getting stuff off

Might also check the price for the tremor spare you already have 1 might be cheaper to find 3 more

https://www.4wheelparts.com/p/pro-comp-51-series-rock-crawler-steel-wheels/9309?Bolt+Pattern_PQMS=6+on+5.5&Wheel+Diameter_PQMS=17+Inches&Construction_PQMS=Steel 80 bucks each but offset may be to much for ya

White and the factory mag metalic is the route im going. Enough color variation in the cactus imo

Have been tossing around the idea of painting the intercooler since i swapped the grill. Thank you sir for the motivation because now i have too