Search results

165lbs $513 on Amazon (plus tax)

Humm. ... I am just realizing your cover is a different model. I have the Sentry CT. I did not get an auxiliary rail, not sure if there should be one for that cover, but it sounds like something like that is needed. I'll call Truxedo tomorrow, given how tight the rest of the cover fits, I...

Excuse the crazy heavy pollen, it's full on spring here. But this is a close up of the front gasket.

So I just installed the same cover. Were you able to eliminate the gap between the cover and the front of the bed? It seems like that is far from a weather proof seal. The rubber gasket is basically floating. I have drop in liner, but I would guess the gap would be worse with spray in.

I went through the same thought process. I am mostly putting 14' SUP boards up there, and I find they do fine with the shorter spacing. I also may put a 14' kayak up there from time to time, and would probably put front and rear tie downs to the bumpers. Aside from the weight limit of the HD...

I was going to go with the HD, but with the weight limit from the cover adapters at 185 pounds the expense didn't make sense. You not only need the HD, but you need a rolling canaster cover like the Retrax which is also much more expense and harder to remove. So this set up was about 1/3rd the...

Just installed. 60" bars are a little wide, 50" are too short on the rack (tried both). Bed cover looks and works great, secure, but there is a large gap at front due to the drop in bed liner at front being much lower than sides, need to call and see if I installed right or need a bigger gasket.

When my tires were overinflated with the fx4, my truck was bouncing all over the place. No way with those shocks is mpg improved.

Did you check your tire pressure? Most of us seem to have overinflated tires from factory.

That's what she said!

Passed my first one on 41 in Mt. Pleasant (Charleston) SC a few days ago.

That part looks correct for the bracket, but says Class I in the description. It can't be class I as the bumper alone tows more than that, and it has a 2" receiver. I did confirm it does not have the wire harness or the 7 pin connector. I know the bumper mount connector is on back order. I...

Compared to my last vehicle, the auto start stop is significantly less disruptive. I barely know its there, and haven't minded it as much.

That is the same as the shorter cab. I am wondering if there is a typo in their instructions... seems odd that both cabs would have the same placement.

I just ordered the yakima rack because I am hoping the posts are a little smaller looking than Thule's. Thule seems to have the right crossbar length at 53". Yakima recommends 60 which looks too long to me, I also ordered 50 which might be too short, they say you can't cut them. The Yakima...

So looking under truck it looks like there is a plate in the bumper and a wiring harness that needs to swap out. The part I referenced above looks like its the receiver plate needed. Now I am just trying to figure out if it comes with the wiring harness, or if there is another part.

I imagine there would be room for the amp where they mount it for the b&o?

Anyone upgrade their XLT speakers?

Arent there airbags in the seats?

Mine has GPS too, so if I get accused of speeding, not stopping at a stop sign, running a light, hopefully I can prove otherwise. I"ve had kids in neighborhood run out in front of my car. First thing a parent who wasnt watching their kid will say is I was speeding. Video proof may save your...