ARB Compressor Install - Ignition wire/fuse

[Booster]

Hi all, I'm trying to wire the red/yellow wire in the switch to an ignition source. I can't find a fuse that becomes hot only with the engine running, either in the engine bay or cabin fuse box.

Can anyone tell me where to take an ignition source from an Australian Ranger Raptor please. I've searched high and low for an answer to no avail. Thanks!

Sponsored

 

[DrewKD88]

Fuse 22 is 5amp ignition powered. Not in use.
Fuse 37 is 20amp ignition powered. Not in use

 

[Booster]

Fuse 22 is 5amp ignition powered. Not in use.
Fuse 37 is 20amp ignition powered. Not in use

Cheers man. I put a multimeter on both of them and get nothing?

 

[DrewKD88]

Cheers man. I put a multimeter on both of them and get nothing?

Are you looking at the fuse box that is located inside the cab under the steering column to the left? On this forum run a search for fuse 37. You should find lots of info there. I am using that fuse for my Switch Pros.

 

[dmeyer302]

Are you looking at the fuse box that is located inside the cab under the steering column to the left? On this forum run a search for fuse 37. You should find lots of info there. I am using that fuse for my Switch Pros.

He's got an Australian Ranger which may be different. Check the manual for one listed as "spare".

Here's what I did.

 

[Booster]

He's got an Australian Ranger which may be different. Check the manual for one listed as "spare".

Here's what I did.

Cheers for your help guys. I ended up just using fuse 37, as I couldn't find one that was motor only. Anyone in Australia who get stuck wiring it in with a stedi toyota push button switch, pm me and I can help.

Sponsored