Cordless Tool Recommendations

[D Fresh]

It's also there at low speeds but if you want to just hear the noise with no RPMs you can

I've heard it on my Milwaukee drill, but never my other tools.

It's not annoying enough for me to worry about in my opinion. The only time I operate my drill that slowly is for a short second while starting to keep the bit from walking off my mark.

I get if it annoys you. To each their own.

Sponsored

 

[jss81258]

Its most noticeable if you push the trigger in enough to not move the chuck but start engaging the motor. This was also on the brushless models. Brushed most likely would not do that.

Ok, I was curious so I had to go check. My M12 will whine, but my M18 does not.

 

[lawrench]

Ok, I was curious so I had to go check. My M12 will whine, but my M18 does not.

Really? my M18 goes bang when I pull the trigger.

 

[jss81258]

Really? my M18 goes bang when I pull the trigger.

Judging by the tags still on the gun, how do you know? ?

 

[lawrench]

Judging by the tags still on the gun, how do you know? ?

Well, the picture was taken after it was acquired. But I get your point. Because everyone takes pictures of their tools while using them.

 

[jss81258]

Well, the picture was taken after it was acquired. But I get your point. Because everyone takes pictures of their tools while using them.

Like this? I have no safe queens. And, I do like Sigs, and have a couple of P229s in 357 Sig. I guess we're getting plenty off topic!

Sponsored