Search results

I have a 21 tremor and was getting an annoying squeak from the rear suspension. Today I jacked up the tea part of the frame to relieve pressure on the suspension, the cleaned and greased the plastic spring pad cushions that are sandwiched in between the leaf springs. It fixed the squeaking, for...

They look taller than they are, they are really about 3 1/2 in tall

I mounted then in place of the dash tray

I added the PPE pan to mine as well and installed a "Glowshift" brang temp gauge in the threaded side port. It seems to have dropped my trans temps about 8 to 10 degrees, and in the Texas summer you need all the help you can get lol.

I know this was an older question but I attached the wiring diagram and replacement procedure for the Tremor Aux switches, I hope it helps someone.

Yes I realize the optimal operating temp. I have an inline trans fluid thermostat that limits the flow until it reaches a specified temp. Do to my OCD, I wanted something that was a little overkill just in case I am towing through Houston TX and its 113 degrees with 85% humidty and bumper to...

I fabricated the base and trimmed down the gauge pod side. They the gauge pod and gauges are from Maxtow made by Glowshift gauges. I have the trans temp, the oil temp, and coolant temp. The Maxtow series is mainly for Diesels so they didn't have a specific set. I had to purchase them...

Yes, I did that about a month ago. I replaced the factory plastic pan with a PPE aluminum finned pan as well as replaced the transmission filter. I was surprised at how dirty it looked with only 2k moles on it. The pan has a plug in the side for a temp sensor so I added a trans temp gauge from...

I have already installed the "Factory" accessory trailer brake controller and plan on towing a small RV camper next summer (under 6000 lbs.). But, before I tow anything I am going to upgrade the rear shocks, and add a set of Timbren SES rear bump stop spring helpers. Then finally the Hellwig...