Search results

What gets me upset i here nothing from them.. I will go see my upholstery guy to see what he can do to fix it. He did a great job on my mustang interior.

Asking if anyone else had the stitching come loose on their cover. Honestly it just over a year old and bet it’s only been open less than 50 times..sent them a email but got no response from them and it’s been a week..

Dealer will say “I have no idea’’:LOL::LOL:

What’s involved with the inspection?

its where they were going to put the controller for the rear and passenger windows to be automatic

Threw the mail? Lie about it being liquid?

Wondering how to ship oil to black stone? I have the container but post office frowns on sending liquid threw the mail.

So those of you that installed jimmys pipes and cooler how does it perform? I have been busy with a bathroom remodel so no time to do it. My truck is stock so just looking for experience. Thanks

it’s a part that is worth waiting for for sure.

If you go with the icon rear leaf kit make sure you drill a hole in that one spring that does not have the spring cushion or it will squeak. I added F150 cushions.

I notice it just about every time I pull out in traffic where you need to get it going so the guy you pulled out in front of don’t flip you the bird.

So when it shifts in 3 gear with into the gas fairly heavy[not to the floor]is hesitatesa few times and seems like it’s holding back then its fine. Not sure if it’s the trans or not as I have read thew a few posts. Any thought about this. I took it to the dealer and like usual they cant...

hardest part for me was getting the dam original one loose

Yes I agree 100% they should just have a straight fitting coming off the breather..

I contacted UPR and they sent me a piece of hose and a couple fittings At no charge as long as I send them a few pics of what I did to install the cover. Just had to shave the inside of the cover very carefully.

Mine came today, how long does it take to do the swap?

Does it really matter if the fluid level is a 1/4 or a 1/2 quart low? Mine was low from the factory.

Looks like some of you have a handle on this and know what you’re doing. For us that have the skill to do the mod but don’t have the skill on what are the right parts to get and what to wire where, can there be a parts list and maybe a few pic’s of what to cut/splice where and how to run the...

Also have them check the spring bolt that holds all the springs together. I have the same issue after the dealer did the spring shims to try to correct the shake of the drive shaft..

Well I got an email from Jimmy and my stuff is shipped..