Actually found the the wire in 2 pieces and the black hose covering ford uses. The connector was still in bottom of positive terminal so I pulled it out without dropping it (actually tied string to it just in case). I have a lot of colored wire so I soldered a piece of wire to the connector...
Hello,
Anyone know what this wire goes to? Mine was eaten by a rat! It's a single pink wire attached to a connector underneath the large positive battery terminal.
Mine:
Should be an easy fix after I get some tubing to match the factory black non shrunk material and get the underneath...
Bak sent me a new Bakflip Mx4 to replace the revolver since I have had 2 tops with the revolver that have failed in less than a year each. My bed is line-x lined and as such to use the mx4 I will have to find a place to run the water lines which as I recall was the reason I opted against it in...
The plastic rectangular end of the rubber seals that has a pin that inserts into the hole that
87TxAg has pictured above and I have one pictured next to the label on my last pic.
I have had the Bak Revolver X4s on my truck since 2022 and I am actually on my 2nd cover as the first one separated on the edge and now the 2nd one is also. Bak says I can get a new Revolver top or another cover. Which BAK cover should I get? The Bakflip MX4 or another Revolver X4s top...
Here in Florida I wear shorts pretty much year round even at work. I am 5'9" tall and I step in and out of the truck using the step to avoid the rails. I wish I could find a hitch step made out of the same materials. So I could run into that also.
https://www.tygerauto.com/front-bumper-guard-fit-2019-2022-ranger-textured-black-tg-gd6f60478.html
Does this match the Tremors side steps? Can the tyger plate be removed?
What do you guys think?
Have not been able to find a spot for the go pro to keep a stable image of the entire shaft as it's moving. The video I do have is blurry as the bracket I made isn't keeping it still. Back to the drawing board.