Search results

21 Xlt Tremor. Approximately 15k miles. I use the manual shift buttons to lock out higher gears daily. Noticed today that they have lost their function. Anyone else have this happen? A couple on/off cycles didn’t remedy the issue. No codes or errors on the dash.

Looking for the strut side view out of vehicle with spacer bolted to it. Trying to see if the strut studs protrude past the top edge of the spacer. I have the kit but haven’t installed it.

Is it matched angles for each driveshaft section or within 1-2 degrees that works best? I am going to add the BDS shackle and want to figure out if my angle will be kosher prior. I've already had the shim and new driveshaft TSB performed which didn't do much. I've been told that 1" of shackle...

I know the normal answer is to extend the link to put the bar at the same angle as stock. I'm about 2.5" of level/lift on the front on my Tremor and was considering extended links. I found a few options that would work but also stumbled across the Dobson links. They claim they have to run a...

Anyone knocked out the lower front shock studs and replaced them with regular grade 8 bolts? I see the fox kit uses bolts and it makes installing the coil assembly easier as you don't have to push the lower arm down as much to clear the tower. I wonder if the knurling from the studs will cause...

Anyone running these two items in harmony? I have the catch can already. Looks to be the same location as the 589 bracket. Want to be prepared for the worst when I install the winch mount.