Search results

The aFe BladeRunner Intercooler Pipes

Installed aFe BladeRunner Intercooler Pipes

Just installed mine today, the written instructions are horrible, it took me and a super mechanically inclined buddy with all the right tools 4 hours to change then. Super pain in the ass.

I had the same question as you. Just installed mine today, the written instructions are horrible, it took me and a super mechanically inclined buddy with all the right tools 4 hours to change then. Super pain in the ass. Was not able to test the results as we are in the middle of a storm...

Looking good, now you need Fog Lights. https://www.ranger5g.com/forum/threads/wts-stock-fog-lights.4503/

Finally got mine today from Levittown Ford, its worth the wait for their PRICE and the noticeable power difference

Installed the Roush Cold Air Intake

Finally arrived !! Roush Cold Air Intake from Levittown Ford

or, 3. this bike rack was retrofitted for this truck not taking into consideration that some of us have the 5' length bed and could not close the tail gate without having to move the back wheel to the side creating an awkward angle and pressure on the fork (see attached picture). The racks...

Josh, are you still liking and recommending the E-Boards by AMP Research ?

I think the pressure you put the fork under by not having the bike straight, and then you add to that the bouncing around, i think it might have been why the fork needed to be repaired.

I have it set up for three bikes (2 MTB, 1 Road) but could not fit all three with the gate up. That is why i got the bed extender so i can carry all three. BTW when i use to carry my MTB with the gate up but i would move the back wheel to the side so it would fit, i messed up my front fork. so i...

No, i will let the manufacturer do that. They work fine for my intended use.

Let’s start with i don‘t work for BuiltRight Industries, also if you go on their site they dont show these Molle bags being used inside the trucks, they are attached outside in the truck bed fastened to their proprietary bedside rack system. I went ahead and decide to combine two of their...

So far so good, looks like anything you could fit in it will have the room for the seat to lock. It’s not like the bags can fit your kitchen sink ?

Yes they lock up with no problem

Here is the link to the Tech Pouch page: https://www.builtrightind.com/products?category=MOLLE+Pouch To hang them i used their Velcro Tech Panels, see link here : https://www.builtrightind.com/products?category=Velcro+Tech+Panel I attached the velcro tech panel to the back seat rug covered...

MOLLE Tech Pouches from BuiltRight Industries. Installed behind rear seats, using it to store all the stuff i had back there (recovery gear, tie down ropes, some basic tools, tie wraps ...). They look great, sturdy and well designed.

MOLLE Tech Pouches from BuiltRight Industries. Installed behind rear seats, using it to store all the stuff i had back there (recovery gear, tie down ropes, some basic tools, tie wraps ...). They look great, sturdy and well designed.

Installed Turbosmart BOV Kompact Dual Port Anticipating some questions: Bought at Stage3MotorSport It took about 10 minutes to install I already have the Borla Performance Cat-Back exhaust S-Type system installed Yes i felt the difference right away, this combination of mods pushes you back on...