Search results

Oops - you are correct. I did not scroll down far enough to see the SYNC ESN. Thanks.

I tried to do the map update and got an error telling me my ESN was not valid. Called the number given at Ford and discovered that the ESN Ford has on record is different than what shows up in my truck display. Has anyone run into this and, if yes, how was it resolved?

The controller is needed if the trailer has electric actuated brakes. If the trailer has surge brakes, no controller is needed.

Finished my first extended tow a couple of weeks ago and all went well. My setup is the Ready Brute Elite Tow Bar with the integrated Ready Brake surge brake system. Also have the Roadmaster diode kit for the lights and have a charge line to the Ranger. Towing behind a class A motorhome on a...

If your Lariat has the BLIS (I think it does) there is no room in the light assembly to drill and install an incandescent bulb. Those are very expensive assemblies due to the BLIS radar and I would not want to be drilling on them. I recommend getting the diode kit and be done with it. There...

6 months for Sirius XM and 5 years for Traffic Link and Travel Link. However, if the let the 6 month Sirius XM expire, Traffic Link and Travel Link are gone unless you pay for them.

My first car and my first Ford all in one. 1952 Convertible. Not my actual car. Body rust looks accurate;but, mine did have an intact top. I was a Jr in HS

Benny, Looking for KB3Z-14A411-A. It is a harness for the bed 12V power connection. Really just need the connector for the end that connects to the truck harness if that is available. Want to use it for installing some led bed lights that were given to me. Many thanks, Bill

Ready to hit the road when this madness subsides.

My Service Advisor was supposed to investigate this and get back to me - that was 2 weeks ago. I just elevated this to the Service Manager. He has been very good at addressing my concerns over the past few years. I'll post back here when I hear from him.

Page 110. Also, the Table on p. 112 (Recommended Settings for Cooling) indicates to just set the system to AUTO.

I agree with Mark, In both my 2012 Kia and my 2016 F350 just put the climate control on Auto and the system did what was needed to maintain the set cabin temp. The manual in my 2019 Ranger XLT says: "Switching Auto Mode On and Off Press and release the button to switch on automatic operation...

Ready to to hit the road when this madness subsides.

Understood. Really getting more worried about the financial toll this is going to take on our country. I honestly don't know how working parents and single parents are coping with this. There is speculation that there will be a baby boom in 9 months due to everyone (or at least a lot of...

My comments to your comments: "There's two problems with your numbers:" Note that these are not "my" numbers. They come from the CDC. "(though they aren't entirely correct, which I'll get into)" You did not correct the CDC numbers, just applied some different factors to them.

According to data on the CDC website, from Oct thru mid-March the flu has infected 36 million Americans in just over 6 months and killed around 22,000. Remember, we have a vaccination for the flu. The total COVID-19 infections in the U.S. is currently just over 40,000 and the total number of...

Does anyone have a copy of the actual TSB? My keypad was inop when I bought the truck and dealer just replaced the battery. Said that was all that was required.

No. Mine is an XLT 4X4.

John, I did not drill the brake pedal - I used the clamp supplied by Roadmaster. Pretty sure the cables I received are stainless; but, I will look again. Look closely at the metal spring clips after removing the front fascia. The little barbs that grab the plastic tend to bend outward when...

Finally got my 2019 Ranger set up to tow. I installed the Roadmaster baseplate and ReadyBrake and ReadyStop cables to use with my ReadyBrake Elite Tow Bar. The base plate install was pretty straight forward. I did have to grind a bit off the lower portion of the frame rail on the drivers side...