Search results

I thought my clearance issue was towards the windshield, but it was actually away from the windshield. I fought with it for about an hour until I notched farther forward. Fell right in to place after that. I'm puzzled. What's the clearance issue? My problem is the the front clips are not...

Same here. Mine just will not stay down on right side. Also ordered a new one (and a RAM track to replace this)

Fraid not. you should be able see everything from the pix in this thread

dropped price as I got a goo deal on bedslide, so could use the sapce

already removed but I measured and posted here somewhere. IIRC it is just over 25 inches, My DZ75 goes in easily

Thanks!

Hi all I just installed a Prinsu roof rack and I need to reinstall the roof rails that have been cut. The existing adhesive tape looked about a 16th or eight thick. . Anyone have any idea what kind of adhesive tape I can use to reinstall the trim

Was there. A question

Hi all I am in the process building a rear seat delete I’ve installed a wooden platform and the rear and I want to carpet it with some carpet that matches the Ranger. Does anyone have any idea where I can find matching carpet. I need about 20 ft.² thanks Mark

Awesome, that's exactly what I'm planning, How did you hold/attach the threaded blocks?

just installed one of these. It's dreadful. The screws that hold it on don't line up with the slots, so your having to tighten at an angel (unforgiveable). And then trying to hold a nut underneath while you attach something is almost impossible. (managed it with some masking tape and a skinny...

not sure what that's going to do at all. The big issue I see is a bunch of cheap plastic clips and tabs holding a tray down that how has a ton more weight

Probably going to use the one near the battery in engine compartment. I saw a transit ground point layout diagram, just wondered if there was same for Ranger

Prinsu. Actually arrived early. Installing Sunday

Mine arrives on Saturday. Watched a vid of rhino rack install and they cut the trim with a dremell rather than removing it. They drilled all holes from outside with a collar on drill bit (as it's all rivnuts): Wonder if you could do same with Prinsu

Hi all Does anybody happen to have a diagram of where the ground points are on a Ford ranger 2020? I’m installing a dual battery system a charge controller and distribution center and I want to find an existing ground point for the negative Thanks mark

Awesome. thanks. Can I buy a service manual somewhere? Those "pin type retainers" are a nightmare to get out. Need a to buy a bag of them as they always seem to be mangled. I also seem to break quite a few of the blue retaining clips Those

I need to check. Mine has ford spray in bed liner. I assumed they were metal

Thanks. I have the trim removal tools. So you have to remove the trim behind the seatbelt first? Any other steps?