Search results

message sent

I installed a hitch, 7 pin trailer plug and prodigy brake controller all from etrailer .com. Their directions were spot on. Even if you are using Ford parts you could download the instructions.

I installed an aftermarket hitch. Took less than 30 minutes

Mine was on very tight I have the old clamp style filter wrench, but instead of a handle, it has a square hole for a 3/8 drive ratchet. I could easily reach in with two long extensions and got it loose.

Snow is melting pretty fast now. Getting studded tires changed back out. Hopefully it warms up enough to wash it this week

Going to take off the studded snow tires next week. Wish I was closer. Couldn’t get much further away to any place in the USA. Good luck.

Just installed mine on Sunday. It went very smoothly. 4100 miles since Dec 2nd.

Did my first oil change yesterday. 4200 miles. Put the truck on my ramps and had no trouble installing the fumoto valve. I was able to reach the filter just fine without removing or turning the wheel. Thanks to those who posted their experiences and part numbers.

Installed blue ox base plates, ready brute brake cable and break away safety cable, diode wiring kit. Need to finish up with the wiring plug and LED light bar.

Installed the Yakima Overhaul HD racks last night and blue ox tow bar base plates on Sunday, along with braking stuff.

Grabbed a couple photos before it starts snowing again.

Used some speed shine for a waterless car wash in the garage, then a coat of wax.

Parked in front of the storage shed and one in front of the boat shed

Got my new Ranger XLT FX4 in early December. Sold my 2007 Expedition EL which I bought new. Loving it so far. I bought it off the lot, and it didn’t have trailer tow package, so I have installed Curt trailer hitch, 7 pin wiring and prodigy3 brake controller to tow my snowmobile trailer. Added...