Search results

I like the looks of those 968 lights actually. Just the old school look I was thinking. Thankfully lights don't seem to be backordered like everything else these days, once shrockworks gets my bumper built I should be able to get something on there. I'm hoping I can mount these without...

Out on the trails in eastern Kentucky

Anyone order one of these recently and get an estimate on lead times? I placed an order, asked via e email but no answer. Might try calling them in a bit.

Finally upgraded my wheels/tires. Wheels are very scratched up. Tires have 8/32nds tread left but have been rotated every 5K and very even wear. If you have a use for them make an offer as the best offer gets them, even if that offer is to come pick them up for free! Two of the tires are...

I'm working on a final decision of which minimalist winch mount to go with. I had pretty much decided to go with the hidden winch mount. I had a thought today though that the small bull bar on the shrockworks ultra light winch mount might look good with a couple 6 or 8 inch round lights...

I have some of the Method 705's coming this week. Did you put hubcentric rings on these to mount them? I've been researching but slightly confused on it. Thanks

Reading through all these posts and so far I may have one of the latest Aluminum builds ?‍♂️.....3/20.

Thanks, finally went and found the build date of 03/20. Reading all the posts it seemed a lot of the 20's were steel so I started trying to figure it out, I guess I was early enough to get the Aluminum, which is good since I didn't see the note about the change in spindles until after I ordered...

Hey can someone verify that I'm looking at an aluminum knuckle/spindle? Obviously a newbie to working on my own stuff and want to make sure before I try to fit some new UCA's on. Thanks!

Just looking at setups for a compressor and so far I like this spot! Is there something preventing just trimming that plastic piece to fit around the compressor so that the hood closes normally again? Thanks