Recent content by MFTremor

Hey all, I'm getting a set of BFG KO3s on my '21 Tremor on Friday. I was debating going white letters out and looking to see if anyone has any pictures of their Rangers with white lettering out. Thanks!

I was always curious why the bottom of the bed bulkhead was angled toward the front of the truck. I discovered it is so you can fit a wheelbarrow in the bed and still be able to close the tailgate. Pretty neat Ford!

I thought of that, but the hole I need to run it through is too small and I can't get anything in there to drill it out any.

I dunno, its pretty thin. I'm thinking it would more than likely break in the same place.

And here was my solution: I used some stainless zip ties to hold the cable elbow in place. Hopefully it'll hold up!

Here is the piece that broke:

Found the culprit! Now how do I fix it?

I pulled the back of the seat up and to me it looks like this broke

Earlier today I was adjusting myself in the drivers seat to get comfortable, and I heard a pop and my lumbar sunk all the way in. My question is what parts do I need to replace to get my lumbar support back? 2021 Tremor. Thanks! Matr

I went ahead and changed my fan wire support tube today. The original was still in good shape, but I figured I'd mitigate any potential problems.

I checked it more closely, it actually was pretty nasty.

These spaceship vehicles with their whiz bang electronics sure are touchy!

I just swapped out my engine air filter and the CEL is off. The old filter didn't look that bad, but bad enough I guess.

This just popped up today. Any ideas on what to check first?

Found the source of the clunking! My lower swaybar endlink nut had loosened. All good now!