Search results

SOS pad or the bleach spray

im old school so.... white letters out.....

Thanks

how hard was this install?

you can always drill your own holes for the parking sensors......

Thats a good looking bumper... are u going to drill holes for the collision warning sensors?

Mine still came out. Axle nut removed, axle freed up, bottom coilover studs cut off, sway bar links disconnected. I just took the CV boots off the big end and made sure they slid back in properly and put new CV boot clamps on....

Thanks,, Yes .. I put in the BDS replacement crash bars along with the spacers...... hardest part of it all is cutting the stock crash bars out..

Thank you... Yes im running 1.25" Bora spacers, Fox 2.0 kit front n rear and 1' block lift in back..

East side of Four Peak El Oso Road, a little shoot off there

Some Arizona Desert trails

Just some pics of mine...

What Rooster said... drive bike into bed. attach both tie downs to handlebars, compress front shock if it has one and cinch up straps. Helpful to lean bike to one side a bit when doing that side, then when u straighten up the bike to do the other side, there's plenty of compression going on so...

I had these on my Escape many years ago.. excellent in the snow and ice (AT's)

Mine haven't even arrived yet so I'm no help here. But that fact that I bought 5 says that im hedging my bets they will be good.

Milestar eh? Great choice.. I just ordered my 285/70/17's..... after a ton of due diligence researching these I think they are the best tire Nobodys heard of! I haven't found a BAD review yet. Really quiet on road, about 40k life, soft compound so great for rocks, good siping for wet, AT type...

I went the Powertank route also....... the OP ARB setup does look Nice!