Search results

Loud alarm may be OK, but I am more for a stored charge capacitor with a couple of touch pads on the inside of the handle.

My first oil change after purchase, 14114 miles. Had 13k on it when purchased. I use Mobile One full synthetic, always have.

It's open under the vent grill. Go figure

Roger that, I hevn't been to Ferman in years, bad experience also.

I have been dealing with Walker Ford in Clearwater. Just purchased a 2022 ranger with 13k miles from them. They have been pretty good over the years.

Thanks Guys, I try.

I wanted an FX2, but did not find one, so here goes. Started with these changes - Raptor grill, Valence for tow hooks, Tow hooks, Skid shield, After market crash bars, 3" front lift, Recessed tonue cover, Stainless steel roll bar ( installed the hard way), Change to 17" Fuel wheels and 175R 17...

FYI - Them wanting to take a closer look is no problem. The problem is getting them to do something. I have contact ted them for a week no and all i get is they are reviewing the pics I sent.

I did - gator flush mount. Now if I can get one log enough. Could you possibly through a tape measure front to back on your cover while fastened down and give me a length? Mine is 59 1/4 on one side and 59 3/8 on the passenger side. Thanks Cliff T Taylor

Update. Gauge and gauge pod installed. Fished the Banks cables up thru dash to pod location. Had two as I also installed the Pedal Monster. This pod mount (listed for Lariat model) has a tab on the front end which will go under existing dash, I did not have any luck with sticky option to...

Looks really good. I will post mine when done.

OK Gang, I purchased this gauge pod and have started the install. I used a utility knife to release the glued in vent. The vent seemed to be only glue in the corners. With a lot of patients I ran the point of the knife along the rear and the two sides, and that's where I found the lack of glue...

Thanks, I think I got it now.

Hey Whiplash- wish someone would have said this also. I spent three days and bought two mm sockets to try and remove the nuts. Had a 1/2" breaker bar and 4'cheater with no luck. Called my truck guy this AM and he told me he had no advice, except maybe the bolts only came out from the top, like a...

Thanks Guys - I was also on the _" it can't hold if it's liquid mode.

Good morning tribe, Anyone having problems getting crash bar bolts loose on a 2022 ranger? Tried 4' cheater on breaker bar - no joy. My truck guy said the nuts may be fastened to the frame and bolts come out from top. Any Help?

This morning between rain showers I had a 3" lift installed on the front. Took a couple of hours and also realigned the front end. All done by my favorite shop in Clearwater Fl - S&M trucks

Hello Joe, I now have an XLT and I've been searching for that illusive part number for the valance with the tow hook cut out. I have two numbers but can't seen to iID. the correct one. If you have it ,I would appreciate it. Thanks Cliff

one of the Banks gauges.

OK - That makes sense. But if this actually fits and now we know its glued, we should be able to use. Even if it needed to be glued.