Search results

Gotcha, think I’m gonna order the gasket (and associated gaskets for the job) and replace it, do a good visual inspection and hope that’s it. If the problems persist, then I’ll get rid of it. anyone know if there is a service manual that would cover head removal available?

Ok, took the plugs out and scoped the cylinders.. Here are the plugs 1-4 L to R in the photo.. Looking outward at the cylinder wall of #1 there is what appears to be liquid rivulets trailing from top to bottom of the cylinder.. would that indicate a compromised head gasket? And also, why...

Anyone had this issue? 2019 w/ 90k ish miles. coolant was disappearing, so I immediately thought it could be a head gasket issue, but when I pulled the dipstick it looked / smelled fine. Figured maybe I had a small leak in the coolant system somewhere. So now ~1000 miles later, when I changed...

Correct. It hasn’t done it again in any situation.

I’ve had my 5Star tune on now for about 3k miles. I’ve had maybe a slight drop in fuel economy, but I use the 93 performance tune. (Also could be attributed to the skinny pedal being more fun to push) OP, I had that exact same experience you did with the limp mode / message. However after I...

Jason, here are a couple of shots of mine. It’s dark outside so bear with me on the fuzziness. (I can take some more tomorrow if needed.) If you look at my last pic, the rail should have a section “notched out” to fit around the front of the bed. Mine is back just a little bit from it. Also, I...

Redland, Thanks for the tip. I will be sure and check that. The truck has almost 4K miles on it, and it has the 5Star 93 octane tune. All that said, I went out just now to disconnect the battery and see if that would clear the message, and I cranked it to make note of my radio presets before...

I was driving on the interstate today, and was speeding up to pass a car, when the truck gave me a message on the dash that said "Pre-Collision Assistance Not Available" and then it said "See Manual" and the check engine "wrench" light came on. The engine seems to be running ok, its not idling...

Here’s a couple of pics. Got the adhesive installed at the front lip of the bed. No more “flapping” noise from the rubber overhang.

Big thumbs up for 5 Star customer service! Received my SCT tuner yesterday, and pulled my OBD codes. Emailed them in last night, and they had already sent my selected tunes by lunchtime today. I updated my tuner software and loaded the tune on the truck today. (I will admit that I freaked a...

Did it by myself and in the dark using a work light, and it only took about an hour. It rained a little bit last night, with no water intrusion. The kit had two long strips of sticky sided foam that are not mentioned in the instructions (and I didn’t see any need for). However there was also...

Just got done installing mine. (No pics yet because it was dark when I finished). Went together smoothly, and seems like a great design.

Does the 5Star tune eliminate the auto stop/start in the computer?

I'm in for a LMS Tune! I think you mentioned the tune changes the top speed limiter as well? Do you know what is factory / vs what the tune changes it to?