Search results

These look great. Where'd you get them?

I changed out the entire assembly and that didn't fix so I changed out EGR sensor and all is good.

Hey all, my CEL comes on and off every week or so the last three weeks. Code: P0471 exhaust pressure sensor a circuit range/performance. I replaced the DPFE assembly with the sensor and tubes. A week later, it's back on. Anything I'm missing? 2021 Ranger XLT Tremor 45K miles.

Do these have rear blocks stock?

Ok I'm kinda at a loss right now. I had major clunk and found that carrier bearing was bad. Had this replaced and now I have some driveline vibration. They brought another tremor in on the lift and stated my driveshaft angle is out of spec due to the lift. I just bought this used end of April...

Yeah. That’s what I did. The headlights are a tougher install than the strips in the bumper. I used a box underneath when I lowered the bumper and disconnected everything.

The lights are plenty bright. I definitely wouldn’t say that this is an easy install but it also wasn’t as difficult as it seems. You take it all apart then put it back. I did pay the $ to order an additional set of inserts so I could have them cut up before taking the front end apart. Worst...

My switch just has two wires. Do you need an inline fuse?

So wolfhaus pigtail has a white and a black, white positive to positive of light strip to positive on switch, then what? Switch neg to both negative wolfhaus and negative lights soldered together? the switch throws me off bc I have only done subs where you do the battery with an inline fuse.

Ok, so I’m definitely not an electrician but have previously done some auto electrical work. I cannot for the life of me figure out how to wire the set up I’m wanting. I bought these lights (just prefer them over the strips) https://a.co/d/e2dqtpY and I also ordered this switch (didn’t like...