Search results

Sorry - end of year work and I hadn't looked here for a while. I'm really trying to avoid shipping them. Feels like too much work to get them packed, shipping estimate, etc. If you have ideas on how to make this easy, I'm open to any suggestions.

The rolling the window down trick doesn't seem to help. I have narrowed it down to the rear door speakers though. When I first get into the truck all the speakers sound fine. Then during my commute to work or back home the rear speakers begin to randomly distort. After sitting parked for the...

Did not notice this last winter but noticing it now. Sometimes its there and sometimes its not. California winters aren't particularly cold...its 46 right now and started the weird behavior on the way home from work.

Bump

Used Tremor side steps. Slight scratching on the underside but otherwise great condition. All original mounting hardware included. Tracy, CA

After a long hiatus I’m back to doing mods. This past week I added AFN 5th Gen frame mounted rock sliders/steps. These were a bit of a challenge to install on the drivers side due to proximity to the gas tank and brake lines, but the look and feel very sturdy. We’ll see how they hold up soon I...

When you had the Softopper over the Decked, did you have to remove the cotter pin to collapse/install the Softopper? Is the decked high enough to interfere with the hinge mechanism on the Softopper?

Camping trip to see the Fall colors in the Eastern Sierra

How many people are drilling for front bulkhead buttons, vs velcro, vs magnets? I've got the factory spay in bedliner and magnets just seem to slide all over it so I don't know if magnets will hold well.

Test fit my old Ironman 4x4 awning to my xtrusion overland rack.

Did you set up a switch somewhere and what lights did you use for the bed?

That was my first mod ?

Anyone do a pull with their winch mounted to this yet?

OK - Nice...now I get it. Hopefully that was a picture you already had ;-) So the module goes on that opening and the grommet is inside that opening going to the underside of the truck above frame level?

I know that the stock Tremor tubes are NOT rock sliders and are NOT frame mounted. Any idea how much weight they can support if being dragged (not dropped hard) over something?

Thanks. Where did you punch through?

Was this an existing grommet or a grommet you added? I'm considering ways to get ham radio power/antenna in and out of the cab and without introducing leaks from weather/watercrossings.

Installed a Softopper. Still need to get thicker weather striping and work through Velcro vs Snap issues with the flaps, but still happy with it

UPDATE: No issues since 8/11 with a mix of off-road, in-town, and highway driving. Wheel balance seemed to be the issue.