Recent content by geargrabber67

So far I haven't gotten any time to address it. I think I'll shim the center bearing until the two drivelines are 180 degrees out from each other and update you all. I'll also probably grease the slip yoke after that. I think the 1.2⁰ at the pinion is ok and is actually preferred to account...

I've got a 2019 FX4. I swapped the saggy stock leaf springs out for some OME 650lb continuous load springs and some 5100s all around. This gave me 2.5inches in the rear and 2 inches in the front. I've got the common driveline vibration when accelerating from a stop. I've checked the pinion...