Yakima Overhaul HD - rebox

Discussion in 'Racks, Carriers, Toppers, Cargo, Bed Mods' started by rooster, Aug 2, 2019.

  1. rooster

    rooster Active Member

    Vehicle(s):
    STX FX4 SuperCrew
    Joined:
    Oct 8, 2018
    Location:
    betwen PVD and BOS
    Posts:
    34
    Likes Received:
    28
    Garage Profiles:
    1
    The Yakima Overhaul HD is a nice rack ... strong, well made and aesthetically pleasing, easy to remove the rear rack when hauling dirtbikes. Nice tie down points on the towers and crossbar ends too.

    It is just a bit out of reach in price I think at $950. I then found a rebox (sold as new with warranty) for $759 with 55" crossbars. This brought it into my "I'm ok with this" price range.

    Here it is installed, 55" works for me, 60" crossbar might be offer a little more elbow room. Height setting in this picture is 22" which brings it over the shark fin antenna base.

    48438397081_cf6e30a811_b.jpg
    48438397701_b6e4cb6bb9_b.jpg
    48438543452_a7ac612302_b.jpg
    48438543417_2d3163ecd4_b.jpg
    48438395551_f4a13594fd_b.jpg
     
    Tracy Bowman likes this.
  2. the1mrb

    the1mrb Active Member

    First Name:
    Matt
    Vehicle(s):
    2019 Ford Ranger, XLT FX4
    Joined:
    May 22, 2019
    Location:
    Duluth, MN
    Posts:
    40
    Likes Received:
    71
    Occupation:
    Engineer
    Garage Profiles:
    1
    Looks nice! I really wanted to get one of these, not only because it looks good but the adjust-ability of it seemed nice to me too. But when I discovered you can't have a tonneau cover with it, it fell off my mod list. Especially since a tonneau cover was a must have for us. I know that you can get the special retractable cover made specifically for use with these clamp-on bed racks, but I don't like retractable covers (seem too easy to break or jam) and its certainly more expensive than the simple roll-up one I ended up getting. Disappointing for sure, but can't everything I guess.
     
    Tracy Bowman likes this.
  3. Lunchbox88

    Lunchbox88 Well-Known Member

    First Name:
    Logan
    Vehicle(s):
    2019 Ranger SuperCrew FX4
    Joined:
    Jun 21, 2019
    Location:
    Missouri, USA
    Posts:
    106
    Likes Received:
    60
    Looks good, thanks for the writeup!
     
    Tracy Bowman likes this.
  4. rooster

    rooster Active Member

    Vehicle(s):
    STX FX4 SuperCrew
    Joined:
    Oct 8, 2018
    Location:
    betwen PVD and BOS
    Posts:
    34
    Likes Received:
    28
    Garage Profiles:
    1
    Yep the cover that works with this is not something I'm interested in. I think the roll up container at the front of the bed takes up 11-12" of bed space too, so no go for me. I'm getting a huge waterproof cargo bag for the bed for my "must stay dry" camping stuff, I don't need a bed cover full time.
     
  5. the1mrb

    the1mrb Active Member

    First Name:
    Matt
    Vehicle(s):
    2019 Ford Ranger, XLT FX4
    Joined:
    May 22, 2019
    Location:
    Duluth, MN
    Posts:
    40
    Likes Received:
    71
    Occupation:
    Engineer
    Garage Profiles:
    1
    Ahh, yeah, that's a good idea. Sounds like a good setup!
     
  6. j_slate

    j_slate Member

    First Name:
    Jake
    Vehicle(s):
    Edge... until I can get a Ranger when I graduate
    Joined:
    Aug 9, 2019
    Location:
    Utah
    Posts:
    10
    Likes Received:
    5
    Occupation:
    Structural Engineer
    Looks great! I've been going back and forth between the Overhaul and the Outpost. When the Overhaul is at it's lowest point does it stay below the cab height? I wish Yakima would make one that goes from 13" to 22"....
     
  7. bobkat

    bobkat Member

    Vehicle(s):
    2019 ford ranger fx4
    Joined:
    Jul 3, 2019
    Location:
    Florida
    Posts:
    9
    Likes Received:
    11
    Garage Profiles:
    1
    #7 Aug 14, 2019
    Last edited: Aug 16, 2019 at 12:50 PM

    This is at the lowest height

    IMG_0257.jpg
     
  8. bobkat

    bobkat Member

    Vehicle(s):
    2019 ford ranger fx4
    Joined:
    Jul 3, 2019
    Location:
    Florida
    Posts:
    9
    Likes Received:
    11
    Garage Profiles:
    1
    i Am going to raise it up a couple of inches
     
  9. Desert_5G

    Desert_5G Well-Known Member

    First Name:
    Eric
    Vehicle(s):
    Tacoma
    Joined:
    Oct 28, 2018
    Location:
    Arizona
    Posts:
    335
    Likes Received:
    191
    Garage Profiles:
    1
    As much as I like that rack. It's perfect for my Kayak. Yet is so $$
     
  10. RangerCat

    RangerCat Well-Known Member

    First Name:
    Brian
    Vehicle(s):
    2019 Ranger Lariat
    Joined:
    Jan 18, 2019
    Location:
    Kansas
    Posts:
    135
    Likes Received:
    91
    Wow, that's a great deal. Where did you find it? I have been wanting the same setup but can't pony up the full amount. It's crazy expensive!
     
  11. rooster

    rooster Active Member

    Vehicle(s):
    STX FX4 SuperCrew
    Joined:
    Oct 8, 2018
    Location:
    betwen PVD and BOS
    Posts:
    34
    Likes Received:
    28
    Garage Profiles:
    1
    I found the rebox at rackwarehouse.com who are based out of Vermont.
     
  12. 808matt

    808matt Active Member

    First Name:
    Matt
    Vehicle(s):
    2019 Ranger FX4 Sport Package, 2015 f450 Bucket Truck
    Joined:
    Apr 17, 2019
    Location:
    Hawaii
    Posts:
    34
    Likes Received:
    23
    bit pricey but i think i'll be getting these 2 in the future

    yakima.jpg
     
  13. RangerCat

    RangerCat Well-Known Member

    First Name:
    Brian
    Vehicle(s):
    2019 Ranger Lariat
    Joined:
    Jan 18, 2019
    Location:
    Kansas
    Posts:
    135
    Likes Received:
    91
    Thanks, I'll check them out!
     

Share This Page