Tremor wheels vs Ranger Raptor wheels

[Espo78]

Can anyone say with absolute certainty that both the Tremor wheels and the Raptor wheels are the same width and offset? It would seem like the obvious decision that the wheels are identical save for the color, however I have seen several anecdotal posts about the Tremor wheels being wider, or sticking out further than the Raptor wheels. To me this does not make sense but it would be nice to confirm.

For reference the Raptor wheels are 17x8.5 with +55mm offset, 6.999" backspacing. I can not find specs for the Tremor specific wheels or any link to purchase them.

Sponsored

 

[Espo78]

same if this thread is correct

https://www.ranger5g.com/forum/threads/tremor-stock-wheel-size.14005/

Ha! I was just reading that thread. However it appears everyone is using the same information which was originally found for the Raptor wheel on the Summit website. I have never seen anything "official" about the Tremor wheel.

 

[Scooter]

$850 per wheel. Wow pricey !

 

[Espo78]

$850 per wheel. Wow pricey !

That should be for the set of 4 including center caps and TPM sensors.

 

[Dgc333]

That should be for the set of 4 including center caps and TPM sensors.

Factory wheels have always been extremely pricey. My son manages a tire and service center and one of his customers came in with a broken wheel after driving through a massive pot hole. It was a chrome plated aluminum Jeep wheel and a replacement was $1200.

 

[CarbonTremor]

Pretty sure the specs are the same with the only differences being in color ( magnetic vs dyno gray) & the center cap design

 

[bfastr]

I have a set of 18" wheels and a set of Tremor wheels. there is a definite difference in offset. pretty sure the back of the Tremor wheel is stamped 42 for the offset. I did a comparative measurement between the rim edge and the flat of the wheel mount surface and there was an obvious difference.
as I recall it worked out to be the difference between 55 and 42 MM ( about 1/2")
Doesnt really answer the OP's question tho.

 

[Dino]

Info obtained from Bronco forum.

Tremor wheel: Part# HB3C-1007-A1A 17x8 offset +42

Raptor wheel: Part# JB3C-1007-M1A 17x8.5 offset +55

 

[Aonarch]

Info obtained from Bronco forum.

Tremor wheel: Part# HB3C-1007-A1A 17x8 offset +42

Raptor wheel: Part# JB3C-1007-M1A 17x8.5 offset +55

Correct

 

[SgtT11B]

My brother just had his BFG KO2 RWL installed on his Tremor. They are in fact 17X8 ET42, somewhat disappointed as he was hoping they were 17X8.5.

 

[Aonarch]

My brother just had his BFG KO2 RWL installed on his Tremor. They are in fact 17X8 ET42, somewhat disappointed as he was hoping they were 17X8.5.

The Tremor wheels have a lower offset which is better.

8" wide works for any big tire you'd run on a Ranger.

Sponsored