Stripe Location?

[Ronbo]

Looking for some input on where to locate these side stripes I picked up.
View attachment 19690
#1 (Original)

#2

#3

View attachment 19694
#4

Sponsored

 

[AZLightning]

I like the 3rd and 5th pic location, 2nd looks too much like a mustang

 

[HenryMac]

I like the 3rd and 5th pic location, 2nd looks too much like a mustang

I like the height of the 4th, but push it backward similar to the 5th. Something like this... sorry for the bad photohack.

Have you tried flipping them side for side, where the stripe comes out of the black wheel flare and then goes up and back?

 

[Roofhopper]

I think maybe try #4 but push the leading edge of front slash to fall in line with leading edge of fender vent

 

[FULLSCALE]

I like the last one but also agree that you should try swapping side for side and see if you like them upside down.

 

[Sandman Ranger]

#2 Mustang.
Tune it to fit.

Would rather have strip along bottom of doors or RANGER logo on bed sides.

 

[DHMag]

I like the height of the 4th, but push it backward similar to the 5th. Something like this... sorry for the bad photohack.

Have you tried flipping them side for side, where the stripe comes out of the black wheel flare and then goes up and back?

The only downfall to placing it lower on the door and he would get into the body contour.

I chose #3 but up an inch or so, so that it's inline with the fender vent.

 

[Ranger's My Middle Name]

I like #1 best.......

 

[u wish u could ride]

I like #1 best.......

yup!!

 

[khyros]

#3 with only 1 of the hashes at the front so it aligns with the badge.

 

[chasvs]

Push it down so the Long lines are Above, on, or below the Style Line at the lower end of the doors. Have the 2 Down angles stripes extend from below the Vent on the front fender.

#4 Move stripe Down about 10-12in. and Forward 3-5in. depending on actual fit.

 

[Dr.Me]

I'm not a "stripes on my truck guy" but for the sake of helping I'd say the last picture is the subjectively the nicest if you can make it flow with the vent/badge

my drawing is horrible

Sponsored