Anyone install one? Did you do it the so called easy way by jut lifting the console plate? Quite tight under there. Did you have any trouble getting the wire disconnected and the lead from the eliminator plugged into the switch?
Thanks
Back in thr '90's someone made a clear one that you could have painted on the backside to match your truck. Does anybody know of a clear one you can have on the backside??
Thsnks
Having a problem mine. They are deploying fine but the driver side does not retract completely. If you evdr so lightly assist with theffh toe of your shoe it retracts fully. Passenger side did it once but that side is not used often.
Anyone have this problem?
Thanks.
Has anyone re-aimed head lights after a lift of 3" to level truck??
I was told by the shop doing the wok they have not had any issues with not re-aiming. I do not have a level spot in my driveway to do it my self and using the back wall of the garage will not work either.
Thamks
George
Has anyone put Gibson twin tailpipe exhaust on their Ranger, Kit 69550 or 69550B? If so how is the sound both outside and inside the cab? I cannot find a sound bit on line.
Thanks
George
Is there any way to get Auto Up/Down for passenger side windows from both passenger side and driver side without using the RedTelk module from Australia? Don't really want to sen credit card number outside US
Thanks
I am thinking about putting dual exhaust, the kind that splits after the muffler, has anyone done this?
Are the yuou happy with it?
How is the sound?
Would you do it again?
Thank you
George
Has anybody connected their Raptor grill lights to their DRL'S so they are on in the day time? If so where did you make the connection? Any problrms or issues like the tailgate lightbar?
Thanks
George
Need to set truck on jack stands. If put them on the frame rails thy will be in the way. I usually put them in the rear on the rear axle and in the front on the frame rails. i see where I could them put on the frame in front of the front axle is that ok? Is the rear axle also ok?
Just...
Based on a guess I believe they are the same, anyone know? The reason for the question is I am going to put Amp-Research power steps on my Scab. They use the same kit for both Sacb and Screw but they have you cut them to shorten them for the Scab. If the wheel base is the same it seems there...
Can this be done in the Ranger world? Has anyone done it?
Some in the F150 world are swapping the 4x4 rear axle blocks (the ones between the rear axle and spring) for the ones from a two wheel drive effectively almost leveling the truck.
Thanks
George