Search results

Looks like the engine covers are available… any codes for these?

No worries, I get it. I wasn’t sure how much over stock the installed add a leafs were on mine, so I was nervous pulling up to the shop to see the results. Turned out perfect and the truck drives so much better than with the add a leaf. Can’t say it’s better than stock since it was lifted when I...

From ground to center of fenderwheel arch is Front 39 1/2 Rear42 1/2 Since tire size, inflation etc can change the height as well, I usually measure center of hub to center of fender/wheel arch Rear 26 3/4 Front 24 3/4 Front has an eibach 3” lift Rear icon leafs option. 2

The upgrades continue…. I had my icon leaf springs installed today using the second option where you replace the 3rd leaf for 1.35” over stock … wow… words cannot describe the difference over the add a leaf that it had. It went from rough and bouncy to smooth and solid! Night and day difference...

not trying to state the obvious but did you double check the part number on the box and the strut to make sure they shipped the correct ones? I am not too familiar with belltech, but is there any way you could have seated the lower spring perch upside down? I have seen people do that with...

5 minutes with a socket and few pulls, and it’s like it should have been to start with!

congratulations, your concerns are valid! Wow, in not surehow confident I would be pulling all that withmy truck, but it makes me happy that it is capable!

I am pretty sure at the end of the day, it will weigh maybe just a shade bit more that a 12 pack…. If you are cutting it that close I have to see what you are hauling! Haha

Thanks for the info! Mine is actully more pronounce on the front drivers corner it seems.

Installed some killmat under the storage areas and along the entire back wall of the cab. I didn’t go crazy with it, just wanted to deaden it a bit. I have a turndown exhaust after the axle and wanted to see if it would reduce some of the exhaust note and ambient road noise. I had it laying...

I never realized I had this issue until i saw this thread….. FML …. One more thing to obsess over! It’s only on the drivers side so now I will scour the pages to see how to fix it and probably find something else to check while doing so. Hahahaha

Your right it did! I was amazed that I found it on the forum. It’s an awesome truck and can’t wait to get the last few mods knocked out.

Hey, didn’t know if you still had the scoop. If so, curious if you would sell it separate. I have a filter already. Thanks!

I think they are trying to clear some of the backlog and increase revenue. I believe I saw a video on YouTube where they mentioned that if you had an existing order waiting to be filled you could Opt into one of these…at a higher cost. basically erase part of the backlog by taking people into a...

I came from the Jeep community where you do you…. You make the payments and have to look at it every day, so get what YOU like and do what you want with your coin. Me personally, for that style, I like them! I am honestly more into the fuel / method off-road look, but that’s me. If your stock, I...

Same here on a past purchase. I learned that if you want to pay cash, either finance it and pay it off later, or tell them you are going with a small down payment, get the terms set and while in the finance office, “change your mind” and put down 90% and pay off the balance a few months later...

See….. that’s where I am ahead of the game…. It came with one! Does anyone know the regular intervals for damper rebuilds? I want to make sure it stays in tip top shape so it doesn’t fail when I need it the most. ;) I have done suspension swaps in my last 5 trucks, and this one has the Eibach...

New member from Wichita Falls, Tx with a cactus gray FX4! Funny thing is, I actually bought my ranger used in Oklahoma and afterward found it here on the site! Accordingly, I want to thank the previous owner for trading it in because I love this truck and it already had 90% of the mods done to...

That was my thinking as well, but it was a double edged sword for me. The dealership had the ranger I wanted at a “fair” price for the current market, but they offered my $7k over what I paid for my trade 2 years ago. When the economy tanks, the trade value will go down in a corresponding...