Search results

I had the TSB done awhile back it did not cure the shudder problem. Last week I contacted the service manager and asked if he would recheck the angle and if incorrect redo the TSB with me observing. He agreed. I took the truck in and it measured 4.9*. The technician went back through the tsb...

Mine runs and shifts a lot better after it has been driven awhile. When cold, it acts like it doesn't know when to shift and is pretty jerky. After it warms up, it shifts better. I don't know that getting it warm is what improves it or maybe driving it awhile distributes fluids where there...

I think it is something other than the driveshaft angle causing it. On my truck, it is always there, but sometimes a lot worse than other times. I would think if it were the driveshaft angle it would be consistent.

If I read the TSB correctly, the driveshaft angle should be between 5 and 6 degrees after shimming? I know yours is 5.4. but just wanted to make sure I am understanding the TSB correctly. You said yours was at 6 degrees before the TSB and was 5.4 after. Theoretically, your truck was within the...

Thanks, tmcolegr. I will order one from Amazon now. I appreciate your information.

Tmcolegr, thanks for sharing your info. How do you like your AccuMaster digital inclinometer? I am thinking of purchasing one to see if my dealer did my TSB correctly. Thanks for any info you can share.

I have a 2020 Ranger that the screen has gone black on me two times. Both times it came back on after i shut the truck off for at least 5 minutes and restarted it. If I shut it off and then immediately restarted it, It would remain black. Have any of you had the dealer tell you the cause...

Yesterday was the second time in about two months that my center touch screen went "black" (like it had no power to it). Both times I was able to get it to come back on after stopping and shutting the truck off for 5 to 10 minutes and then restarting. When I stopped, shut the truck off, and...

I continue to follow this thread as my truck still has the shudder after the TSB was done. What I find interesting is our pole on this thread shows that 43 owners out of the 61 who have reported have no shudder at all. I find this interesting, because several owners have reported that all of...

I had mine replaced by the dealer months ago and they are a little better, but still not good. I doubt Ford will do anything more to correct this poor quality. After looking at the sewn seams and the fit up, I think it is a supplier problem that probably will not be addressed due to cost. If...

My rattle is fixed (I think). I was at the dealership today talking with the service manager about something else. I mentioned the intermittent rattle and he said he would like to drive my truck and try to find it. After a short drive, the rattle happened. He reached up and touched the...

I initially said the shudder on my truck did not improve after the TSB. After driving the truck a little more, I now feel I was wrong. I believe the TSB did help some, but the shudder is still there to a smaller degree. So I changed my vote.

It has not been cold enough to run the defrosters. So, I don't believe it is that. After reading about the defroster rattles, I did run mine for a bit and it did not change the noise or create a noise. It almost sounds like a plastic clip/wire/etc that some how bounces into a certain spot...

She wonders that now.

Will any brand of expandable foam work? Maybe I should put the foam in my ears too just to make sure.

I have an intermittent rattle that I think is somewhere behind the center of the dash. It sounds like it is coming from somewhere behind the touch screen, but I am not 100% sure. It can be rattling with every bump and then go away just as quickly. For an example, today I drove to the grocery...

Same here.

My dealer did reflash the PCM. I have not driven it much yet, but in the little I have, the tranny seems to be shifting a lot smoother.