Search results

Man… I need one for my full size spare. Wish I was closer.

There are kits you can buy (permatex) that pull a vacuum, and i've had better results with those than paying safelite. I got 3 chips in the span of two weeks this fall :| still waiting for the temperature to warm up enough to repair. Had 1 chip in the three years prior. Filled it in with the...

It was done by a rodent. Previous owner? no. Current tenant? likely.

Thanks! I've not seen any posts on changing out beyond the lariat, so was planning that route.

How do people feel about this battery (and the lariat sized battery cover)? https://www.walmart.com/ip/EverStart-Platinum-AGM-Automotive-Battery-Group-Size-H7-LN4-94R-12-Volt-850-CCA-140-RC/40685088

7 is the reason I bought an extended warranty. Shudders, delay on engagement, etc. all present at 40K miles. Just hope it shits itself before my extended warranty ends.

My rear rotors are warped. Rather, they warp under heat. When i start a drive I can get 2-3 hard brakes, but after I'll get a bit of shudder. Plenty of life on the pads, rotor looks fairly clean. Just shit rotors from the factory I think. I'll be upgrading them when I do my first set of...

I'm not, sorry! Your local library or maker space likely has a printer they could rent/loan you though. When i took my steelie spare down most of the dirt/debris was on the topside of the rim, so I'd think a cover would catch dirt. I do off road it a fair bit, to be fair.

Sheesh! I hope they replaced it. it’s a bad design by ford to be fair, but I hope this piece of rubber helps protect it.

Depends on the wheels on these wheels it is accessible, but the pad doesn’t impact that. I’d prefer my wheel points up, protecting the outer face, reduced chain length.

Is there a consensus on best replacement? Go with oem?

Quickly threw this together. Printed in TPU, and it sandwiches between the bracket and your wheel. I've got a full size spare, and didn't want to scratch the shit out of the underside of my wheel. Hope someone else can get some use from it! I bet there are other ford trucks with similar mounts...

So my first battery lasted 12 months before all remote start features were immediately useless (it was winter, you know, when you'd want to warm the car). My second battery lasted about 18 months before premature battery preservation. Still starting the car, but clearly on its way. I expect...

So your lights are DOT approved? And I’m fork lift certified? Even your example image has horrific light thrown above the cutoff. illegal, plain and simple.

That's pretenderized meat. you're going to want to get your buck knife and ice scraper. find that puppy in the woods. On a serious note, the deer processor I like using has a part about "road deer" being accepted for processing, but meat quality not being guaranteed hahaha Those things are...

good luck with sale! Question for you - what is hte part # of your tremor center caps? I need some to replace the bronco wheels I have. I've bought a couple sets, and one had terrible offset, and the other was a deep blue instead of the pictured black.

I'd probably not post your personal address, email, etc. in the public part of the forum. If you click the username of an individual there is a "start conversation" which is a "private message" that allows you to message back/forth without it being in the publc.

PM

Might help to provide a zip. Florida is a big town.

Knock loudly. It was 40K miles before mine has started acting up (when cold it will sometimes slip/not engage, which is the new for this mild winter). OP - have you considered removing the tune, all evidence, and an extended warranty? Splash of holy water, salt over the shoulder, and cross...