Search results

It was in stock when I got mine. I just stopped by after work and grabbed it. It's not that big a job to swap it.

Deltapag package. The no way the stock system can turn it on. Lol at my thread and you'll see how i ser it up.

I've been running the mountune for over a year with an electric fan. The only time the fan even kicks on is if I've been sitting in traffic for a while on a hot day and/or the ac is running. I'm running the stock thermostat. And when I decelerate for a bit it even drops below the thermostat...

I've had zero issues. Still got good pad life left.

When it slows down on mine i clean the glass inside and out and it goes back to normal.

Thanks. It is from them not sure who else has one.

Third intake system. This one will end up sealing up with the hood scoop. Just need to get the replacement lid made. Fit and finish is better than the first 2 I had.

Finally got the hood wrapped to match and replaced my homemade ditch light brackets with a store bought set.

I ordeed the front one from ebay and the wrong gears were on the box. I counted the ring and pinion teeth and verified they were wrong.

That's an installer problem there. No one else has had issues.

Even with only 33's it drives so much better in every aspect.

Even though the fiberglass hood is lighter it's still nice to have the struts back after warranty.

That's close to the one used on the middle strip but the front is definitely different. Problem is making sure they're the same size since they don't list them separately. I'll just go to the dealer and see if they have or know which ones they are.

Every diagram i see lists the complete strip and clips. No clips separately. The one at the leading edge of the hood and the one in the middle. Those are the only 2 that uses clips to attach.

Any chance you know which ones are the ones for the 2 underhood weatherstrips?

Good news: I got the new compressor in since the old one died and found the multiple air leaks. One was an elbow that actually rotted through. Bad news: one of the leaks was the pressure switch and no one has one in stock. Half way done. Also installed a replacement underhood light on the...

Replaced the supplied bolts with studs and nylock nuts like factory but in stainless steel.

Took a can and a half but the underside is covered. Just need to wrap the top and it's done.

As I was prepping the vent area for paint it crumbled away on this corner. It was too thin from manufacturing. Bondoglass to the rescue. I'll have the lines cleaned up when it gets wrapped.

Had custom shirts made of my 3 vehicles. This one finally showed up.