My fox 2.0 story

[Jthomp19]

Great service and ship time from stage 3. Yes remove the axle nuts. Make sure the axle shaft is loose before removing old coilover.
Fairly easy and strait forward when the axles loosen and give you room. My driver side was a nightmare. Got the inner cv to reseat after several hours of tedious rotations/pushing and tapping. Glad I saved money installing myself but damn. Now it’s level, drove around the block so far. No noises or binding. Time to go to the alignment shop.

Sponsored

 

[Bob902]

Looks good.

 

[RangerJoe99]

Looks good! Did you use the out-of-the box setup, or make any changes to the ride height when you put these on? I just ordered the same for mine from Stage 3; can't wait to get mine installed!

 

[Jthomp19]

No changes. They were perfectly set to 2” level. Just make sure your axles loosen from the hub end. It was a fairly strait forward swap out.

Looks good! Did you use the out-of-the box setup, or make any changes to the ride height when you put these on? I just ordered the same for mine from Stage 3; can't wait to get mine installed!

 

[RangerJoe99]

No changes. They were perfectly set to 2” level. Just make sure your axles loosen from the hub end. It was a fairly strait forward swap out.

That’s what I thought, just panicked a little! Didn’t want this to happen

Sponsored