ToothRanger
Well-Known Member
- First Name
- Kyle
- Joined
- Feb 14, 2019
- Threads
- 4
- Messages
- 114
- Reaction score
- 171
- Location
- South Texas
- Vehicle(s)
- 2019 Ranger Lariat FX4
- Occupation
- D.D.S.
- Vehicle Showcase
- 1
- Thread starter
- #16
MirrorTap Installation:
- pull down firmly on the upper plastic housing
- locate the light grey connector (w/ 3 wires) and disconnect male & female (shot was taken before tightening Blendmount fully to stem. Don't flame me)
- Insert positive (red) wiretap below the Blue (switchable 12V) wire
- Insert ground (black) wiretap below the Black (ground) wire
- Heat shrink your connections
- I used a 5/32 bit to make an opening to route my cable through the plastic housing
Sponsored
Last edited: