justspeed7
Active Member
Would this work?
Sponsored
Yes that will work since it’s a Micro 2 FuseWould this work?
Just do a re-set of the function. I had the same thing happen when I unhooked the battery.Ok... so finally got around to having time to work on my truck. I hooked it up last night, worked great!
No only problem is... why won't the auto down work on the driver window?...
Help? Lol
That did it! Thanks!Just do a re-set of the function. I had the same thing happen when I unhooked the battery.
Resetting the Memory of the
Electric Windows - Vehicle with
One Touch Up/Down on Driver
Side only
Note: The bounce back feature remains
turned off until you reset the memory.
In the event of a flat battery or after the
battery is disconnected from the vehicle,
you must reset the memory for the driver
window.
1. Open the window and then try to close
it using the one-touch feature.
2. Lift and hold the switch to the second
action point until you fully close the
window.
3. Lift and hold the switch for more than
two seconds and release.
4. Open the window using the first action
point and try to close it automatically
using the second action point.
5. If the window does not open or close
automatically when you press the
switch or lift it to the second action
point, repeat the procedure.
Looks like most haven't. Use a test light and probe the thicker wires next to the lock one and see which one flashes when you unlock.So has anyone hooked up the third, green wire on the module to enable auto-unfold on key fob unlock or did you use the red and blue wires only so the auto-unfolding only happens when you turn the ACC on? If you used the green wire, which wire in the bundle did you tap?
Thanks RC. Can you think of any reason hooking up that wire would be a bad idea? Functionally speaking I mean...Looks like most haven't. Use a test light and probe the thicker wires next to the lock one and see which one flashes when you unlock.
It will unfold everytime you unlock. Extra wear and tear if all you're doing is getting something out of the truck.Thanks RC. Can you think of any reason hooking up that wire would be a bad idea? Functionally speaking I mean...
That's a good point.It will unfold everytime you unlock. Extra wear and tear if all you're doing is getting something out of the truck.
Factory works the way option 1 does. I don't see the need to unfold everytime you unlock.That's a good point.
Think I am understanding it correctly but wanna double check.29 and 30 are both 30a fuses, just throw a 10a in the add-a-fuse and you should be good.